User manual PHILIPS VR657

[. . . ] Answeringmachine:itflasheswhenthereisanewmessage. It remains steadily on when the telephone answering machine is turned on. If you are using a voice mailbox from your provider, this icon flasheswhenthereisanewmessage. It remains steadily on when the voice messages are already viewed in the call log. The icon is not shown when there is no voice message. [. . . ] Press REDIAL/C to read. 2 Get started Charge your phone Configure your phone 1 The batteries are pre-installed in the handset. Pull the battery tape off from the battery door before charging. 2 Whenusingyourphoneforthefirsttime, youseeawelcome message (country dependent). 3 Set the country and language if prompted. · If the time is in 12-hour format, press / key to select Charge 8 hours Place the handset on the base station to charge the handset. When the handset is placed correctly on the base station, you hear a docking sound. » [am] or [pm]. The handset starts charging. Note · Chargethebatteriesfor8hoursbeforefirstuse. Check the battery level Icon Status When the handset is off the base station/charger, the bars indicate the battery level (full to low). When the handset is on the base station/charger, the barsflashuntilchargingiscomplete. Theemptybatteryiconflashesandyouhearanalert tone. The battery is low and needs recharging. 3 Call Enjoy Call log 1 Press 2 Press . and select a record. · To make a call, press and dial the phone number. 2 Select [Services] > [Reset], then press MENU/OK to confirm. 3 Press MENU/OKtoconfirm. » » Thehandsetdisplaysaconfirmationrequest. All settings are reset. To delete a call record 2 Press MENU/OK. 4 Press MENU/OKtoconfirm. Technical data Battery · HFR: 2 x AAA NiMH 1. 2V Rechargeable 650mAh batteries · SANIK: 2 x AAA NiMH 1. 2V Rechargeable 650mAh batteries Adapter Base and charger: · Philips: S003PB0600050: Input: 100-240V 50/60Hz 0. 2A; Output: 6V 500mA · Philips: SSW-1920UK-2: Input: 100-240V 50/60Hz 0. 2A; Output: 6V 500mA Note · YoucaninstallaDSL(digitalsubscriberline)filterto prevent noise and caller ID problems caused by the DSL interference. Note · YoucanfindtheDeclarationofConformityon www. p4c. philips. com. Frequently asked questions No signal bar displays on the screen. · The handset is out of range. · If the handset displays [Unregistered], register your handset (See the section on Register the handsets). The handset on the charger does not charge. If I fail to register the additional handsets to the base station, what do I do?No dialing tone Your base memory is full. Unregister the unused handsets and try again. Move it closer to the base station. · Ensure the batteries are inserted correctly. · Ensure the handset is placed properly on the charger. The battery icon animates when charging. · Ensure the docking tone setting is turned on. [. . . ] · Ensure the docking tone setting is turned on. When the handset is placed correctly on the charger, you can hear a docking tone. · The charging contacts are dirty. Disconnect the power supply firstandcleanthecontactswithadampcloth. [. . . ]