User manual PHILIPS VSS7902/00T

[. . . ] This contact (N. O. , N. C. ) can activate, for instance, a door opener. Note that the action button only activates the action box designated to the camera input whose picture is shown on the monitor screen. 2 · · · Alarm This function provides alarm inputs to the security system. [. . . ] curtains, potted plants, furniture). g 7 Installation of the PIR 1 Remove the fixation-screw (1) and open the housing by releasing the locking latch (2). Both are located at the bottom of the unit. 3 1 CL 76610006_002. AI 2 2 Remove the circuit board by loosening the fixation-screw (1). Warning: Never touch the face of the PYRO sensor (refer to lay out drawing next page). Knock out the desired mounting holes (1) and wiring holes (2) in the bottom plate. 1 2 3 1 CL 76610006_003. AI 4 5 6 Thread the wires through the knocked out wiring hole(s). Fasten the bottom plate with two screws, using the mounting holes. Fit the circuit board. g 8 Adjust lens position (0°, -5° or -10°) according to desired maximum sensor range (see table below). Remark: Do not use positions +5° or +10° as they do not apply to this PIR. Sensor height 2. 5 m 2. 0 m 1. 5 m 7 Maximum sensor range (m) / Lens position (°) 0° -5° -10° 14 m 12. 5 m 11 m 12 m 10. 5 m 9. 5 m 10 m 8. 5 m 8m Make the interconnections between the PIR and the alarm/action box with the cable supplied (see figure below). 4 3 2 1 NC + _ NC GND +12V 7 6 5 8 CL 76610006_004. AI 1 2 3 4 5 6 7 8 Terminal block (for interconnection with alarm/action box) Lens position (sensor range adjustment) Jumper (walk test LED activated/deactivated) Tamper switch PYRO sensor Jumper (1, 2 or 3 pulse count) Locking latch Terminal block in alarm/action box g 9 PIR +10 +5 0 -5 -10 8 Adjust settings of walk test LED and/or pulse counter, if required. Check if it is locked to the bottom side. Remark: The PIR detector will start detecting movement approximately 2 minutes after mains power-on. PIR settings · · There are 2 jumpers to set the PIR to your own requirements: Walk test LED Pulse counter (1, 2 or 3) See previous figure for the location of the jumpers. Walk test LED jumper installed: Walk test LED is activated. When the PIR sensor is triggered, the LED will light. jumper not installed: Walk test LED is deactivated. Pulse counter Set this jumper to select the number of times the sensor must be triggered (1, 2 or 3 times) before an alarm is generated. [. . . ] The figure below shows for example a two camera system with three accessory boxes. The switches CAMERA # are set according to the camera (input) to which the boxes are designated. g 13 1 1 CAMERA # 67 8 9 5 0 43 21 Colour Observation system talk action menu _ + auto next view CAMERA # 67 8 9 5 0 43 21 FA R < > NE AR 2 2 CAMERA # 67 8 9 5 0 43 21 FA R < > NE CL 66610005_510b. AI Note: Switch positions 0 and those beyond the maximum number of inputs have no function. When two alarm/action boxes are addressed to the same camera input, both boxes will activate the action relay when the action button on the system monitor is pressed. [. . . ]