User manual PHILIPS VSS9900

[. . . ] Strip the sheathing so the wires will become free for the necessary length to connect the UK-mains plug (not supplied). The wires in the mains lead are coloured according to the following code: blue=neutral (N), brown=live (L). As these colours may not correspond with the colour markings identifying the terminals in your plug, proceed as follows: Connect the blue wire to the terminal marked N or coloured black. Connect the brown wire to the terminal marked L or coloured red. · · · · Caution: to reduce the risk of electric shock, do not remove cover (or back). [. . . ] Remark: This mode is only functional when the observation system has more than one camera. 3 Quad mode The images of the (max. ) 4 connected cameras are displayed simultaeously at ¼ of the screen size. next to the text `CAMERA' the numbers of the camera inputs to which a camera is connected are displayed. CAMERA : 1 2 4 After approximately 30 seconds or when a button is pressed the message will disappear from the monitor screen. Remark: After a system reset all system configuration settings are lost. Use the AUTO INSTALL function (see Installation Menu) to scan the system. The Quad monitor will register the camera configuration again. r g 7 2 Alarm function active yes/no (ALARM) · 4 Alarm history list (HISTORY) When you select HISTORY a list with the date, time, kind of alarm and the camera input number of the last 9 alarm events is displayed. HISTORY 94-12-23 95-02-22 96-05-06 96-06-02 96-08-18 96-08-30 16:35:59 01:11:32 04:23:45 23:59:12 13:15:00 03:02:27 POWER ALARM1 CUT1 SHORT4 FAIL1 TAMP2 · With this function you can activate or deactivate the alarm function of the connected camera inputs. Y The alarm function of this camera input is activated. N The alarm function of this camera input is not activated. In case an alarm box triggers an alarm, the buzzer, the alarm relay and the slave alarm information are not activated. The history list is not updated with the alarm event. Select AUTO INSTALL from the Install Menu; Press O until the symbol Y next to AUTO INSTALL is highlighted. Press K or L to start the installation procedure. The text SYSTEM CHECK appears on the monitor screen. After approximately 20 seconds the following texts can appear on the monitor screen: AUTO INSTALL COMPLETED r Display time and date (DISPLAY) With this option you can select if and where you want to display the time and date on the monitor screen (Lower left-hand corner, Lower right-hand corner or off). Select DISPLAY from the Install Menu; Press O until the text next to DISPLAY is highlighted. Press K or L to select between LEFT, RIGHT or OFF. · · · · r 2 Time adjustment (TIME) Use this option when you want to adjust the clock of the Quad monitor. Select TIME from the Install Menu; TIME · · : 2s s3:15:41 The system is installed correctly. After approximately 30 seconds or when a button is pressed the Install Menu returns. CONFIGURATION CHANGED Press K or L to adjust the hours. Press O until the minutes are highlighted. TIME : 23:s5:41 1s 5 r The system is changed; one ore more cameras or accessories have been added or removed from the system since the last System Check was performed. [. . . ] to connect third party cameras or a cash register interface). Mains power adaptor If the camera cable is more than 200m/600ft this adaptor must be used to provide the camera power supply. Colour observation monitor By means of this monitor you can expand your surveillance system with more observation posts (slave monitors). The slave monitor provides the same camera image as the system monitor. [. . . ]