User manual PHILIPS WP3812

[. . . ] If the filter cartridge emits an unpleasant smell, replace it with a new one. Water temperature Do not let water hotter than 50°C run through the water purifier, because this may damage the appliance. Applications Only use the appliance to filter water that meets drinking water standards at the point of use. Do not block the filtered water outlet or connect other devices to it. [. . . ] Push the water selection unit firmly onto the tap from below and tighten the 4 screws evenly. Make sure that you keep the tap in the center of the screw fastener. At the same time maintain pressure on the water purifier housing from below (Fig. Screw the attachment nut firmly onto the water purifier housing (Fig. Make sure the rubber washer is firmly pushed against the tap to prevent water leakage. To avoid this, slightly open the tap and let water run through the filter cartridge for 30 seconds after you install/replace the filter cartridge. The slow stream of water helps to remove any air trapped in the filter. Using the appliance 1 Make sure that the water purifier housing and the filter cartridge are properly installed. Select this setting for drinking, washing vegetables or fruits and for cooking. 1 Turn the water selection lever until the filtered spray symbol is aligned with the indicator (Fig. Do not let water hotter than 50°C run through the water purifier at this setting, as this may damage the water purifier. If you filter water between 35°C and 50°C, the water may have an unpleasant smell. The filter cartridge has absorbed this smell during filtering, but releases it again if you filter water hotter than 35°C. Unfiltered spray Select this setting for washing dishes and other jobs that require a gentle water flow. 1 Turn the water selection lever until the unfiltered spray symbol is aligned with the indicator (Fig. Do not let water hotter than 50°C run through the water purifier at this setting, as this may damage the water purifier. Unfiltered stream Select this setting for a strong water flow. 1 Turn the water selection lever until the unfiltered stream symbol is aligned with the indicator (Fig. Do not let water hotter than 50°C run through the water purifier at this setting as this may damage the water purifier. Cleaning Never use scouring pads, detergents, abrasive cleaning agents or aggressive liquids such as thinner, alcohol, petrol or acetone to clean These substances may cause cracking, discolouration or distortion. 1 Clean the filtered water outlet with a clean toothbrush and wipe off any contamination with a clean cloth. Note: Do not use a used toothbrush, as it may transfer bacteria to the water outlet. [. . . ] You may need to wind some Teflon tape around the screw thread of the adapter. Perhaps the stainless steel screen under the rubber washer inside the water purifier housing is clogged. Clean it with a soft brush and rinse it. Perhaps the tap water pressure is lower than specified. [. . . ]