User manual PHILIPS WP3822

[. . . ] Congratulations on your purchase and welcome to Philips!To fully benefit from the support that Philips offers, register your product at www. 1) a B C d E F g h i J K l 1 2 3 4 M n o P Q R Filter cartridge Water purifier housing Filter capacity selection button Battery low indication Selected filter capacity indication Remaining filter capacity indication Reset button Water selection lever Battery compartment cover Stainless steel screen Rubber washer Adapter A-type B-type C-type D-type Attachment nut Filtered water outlet Unfiltered water inlet Granular activated carbon & ion exchanger Hollow fibre Unfiltered water outlet important Read this user manual carefully before you use the appliance and save it for future reference. Warning This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. [. . . ] If water leakage occurs, wind Teflon tape round the screw thread of the adapter before you screw it onto the tap (Fig. Firmly screw the attachment nut onto the water purifier housing (Fig. Take out the original adapter and screw the D-type adapter onto the water purifier housing. Push the water purifier housing onto the tap from below and tighten the 4 screws evenly (Fig. Screw the attachment nut firmly onto the water purifier housing (Fig. Make sure the rubber washer is firmly pushed against the tap to prevent water leakage. To avoid this, slightly open the tap and let water run through the filter cartridge for 30 seconds after you install/replace the filter cartridge. The slow stream of water helps to remove any air trapped in the filter. Setting the filter capacity When you install the first filter, follow the instructions below to activate the countdown of the filter capacity. 1 Make sure that the water purifier housing and the filter cartridge are properly installed. press the filter capacity selection button. , The default filter capacity of 1500 litres flashes on the display for 4 seconds and is then shown continuously for another 5 seconds to indicate that the selected setting has been set. Note: If you see another filter capacity on the display of your water purifier, press the filter capacity selection button again until the display shows the capacity of your filter cartridge (2500, 1500 or 900 litres). The selected capacity flashes for 4 seconds and is then shown continuously for another 5 seconds to indicate that the setting has been set. Note:When you replace the filter cartridge for the first time and any next time, reset the filter capacity as described in section `How to reset the filter capacity' in chapter `Replacement'. Filtered spray Select this setting for drinking, washing vegetables or fruits and for cooking. 1 Turn the water selection lever until the filtered spray symbol is aligned with the indicator (Fig. Do not let water hotter than 50°C run through the water purifier at this setting, as this may damage the water purifier. If you filter water between 35°C and 50°C, the water may have an unpleasant smell. The filter cartridge has absorbed this smell during filtering, but releases it again if you filter water hotter than 35°C. Note:The LCD display only shows the remaining filter capacity when you use the water purifier at the filtered spray setting and when the water pressure is more than the minimum required 0. Note:The display is off when you do not use the water purifier and when you use it at the unfiltered spray and unfiltered stream settings. [. . . ] Tilt the new filter cartridge 90° backwards and insert it into the water purifier housing. - If the new filter cartridge has the same capacity, simply wait until the setting stops flashing. - If the new filter has a different capacity, press the filter capacity selection button and keep it pressed until the display shows the new filter capacity. Then release the button and wait until the new setting stops flashing. [. . . ]