User manual PHILIPS WP3890

[. . . ] Children should be supervised to ensure that they do not play with the appliance. Before daily use To prevent quick clogging of the filter cartridge, let the water run at the unfiltered setting for around 5 seconds before every use. If the water is highly coloured or turbid due to work on your water network, do not let the water run at the filtered setting until the water is clear. Let the water run at the filtered setting for 10 seconds before use each day. [. . . ] The tap water pressure has to be between 0. If you use the water purifier at a water pressure outside this range, either the filtered water flow will be extremely low or the water purifier will get damaged. Installation a-type adapter For taps with a round spout with a diameter of 16mm, 17. 5mm adapter or 19mm adapter to fit the diameter of your tap (Fig. Screw the attachment nut firmly onto the water purifier housing (Fig. Take out the original adapter and screw the matching adapter (B-type) onto the tap (Fig. Firmly screw the attachment nut onto the water purifier housing (Fig. Take out the original adapter and screw the matching adapter (C-type) onto the tap through the attachment nut. If water leakage occurs, wind Teflon tape round the screw thread of the adapter before you screw it onto the tap (Fig. Firmly screw the attachment nut onto the water purifier housing (Fig. Take out the original adapter and screw the D-type adapter onto the water purifier housing. Unfiltered stream Select this setting for a strong water flow. 1 Turn the water selection lever until the unfiltered stream symbol is aligned with the indicator (Fig. Do not let water hotter than 50°C run through the water purifier at this setting as this may damage the water purifier. Cleaning Never use scouring pads, detergents, abrasive cleaning agents or aggressive liquids such as thinner, alcohol, petrol or acetone to clean the appliance. These substances may cause cracking, discolouration or distortion. 1 Make sure the battery compartment cover is closed properly before you clean the appliance. Clean the filtered water outlet with a clean toothbrush and wipe off any contamination with a clean cloth. Note: Do not use a used toothbrush, as it may transfer bacteria to the water outlet. Note: Do not use a brush to clean the display. Regularly clean the stainless steel screen and the unfiltered water inlet under a running tap with a clean and soft brush. Replacement Replacing the filter cartridge New filter cartridges are available under type number WP3922. [. . . ] - If the new filter cartridge has the same capacity, simply wait until the setting stops flashing. - If the new filter has a different capacity, press the filter capacity selection button and keep it pressed until the display shows the new filter capacity. Then release the button and wait until the new setting stops flashing. The water purifier starts counting down the remaining filter capacity as soon as you use the water purifier at the filtered spray setting. [. . . ]