User manual PIONEER A-10-K

[. . . ] Book 2 ページ ２０１２年２月１６日　木曜日　午前８時５８分 IMPORTANT CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. d3-4-2-1-1_A1_En WARNING This equipment is not waterproof. To prevent a fire or shock hazard, do not place any container filled with liquid near this equipment (such as a vase or flower pot) or expose it to dripping, splashing, rain or moisture. [. . . ] No sound is produced when the POWER AMP DIRECT button is ON. 8 DIRECT button/indicator A-30 On : The indicator lights: When this button is set to ON, sound signals are output directly, without being passed through the various adjustment circuits (BASS, TREBLE, BALANCE, LOUDNESS). This allows reproduction of the signals with greater fidelity, but it disables any settings made with the BASS, TREBLE, BALANCE or LOUDNESS controls. Off : The indicator goes off: The signal passes through the various frequency adjusting circuits. When the indicator is OFF, adjustments can be made with the BASS, TREBLE, BALANCE, and LOUDNESS controls. Français Deutsch 14 POWER AMP DIRECT button/indicator (A-30 only) Press this button when the A-30 is to be used as a power amplifier (page 10). 9 6 7 8 9 10 11 12 13 14 BASS tone control 1 /I STANDBY/ON 4 SPEAKERS B button/indicator Switches the amplifier between off and on. When power is turned on, the power indicator in the center of the button will light. € On the A-10 model, this switches the amplifier between standby and on. 2 STANDBY/APD indicator When power is set to standby, the indicator lights red. When the Auto Power Down (APD) function is on, the indicator lights green (page 11). Use this button to listen to the speaker system connected to SPEAKERS B terminals. No sound is heard from the speaker system. Set to this position when listening with headphones. The center position is the flat (normal) position. When turned to the right, low-frequency tones are emphasized; when turned to the left, low-frequency tones are de-emphasized. € This button does not operate when the DIRECT button is in the on position. italiano 10 TREBLE tone control Use to adjust the high-frequency tone. The center position is the flat (normal) position. When turned to the right, high-frequency tones are emphasized; when turned to the left, high-frequency tones are deemphasized. € This button does not operate when the DIRECT button is in the on position. Nederlands 5 LOUDNESS button/indicator 3 SPEAKERS A button/indicator Use this button to listen to the speaker system connected to SPEAKERS A terminals. [. . . ] Disconnect the power cord and reconnect the speaker cables correctly (page 6). •The unit’s circuitry is damaged. Disconnect the power cord and consult your dealer or nearest Pioneer authorized service center. can’t change input source on A-30. [. . . ]