User manual PIONEER A-223 service manual

[. . . ] However, the method of connecting and operating the unit is the same. WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. This product complies with the Low Voltage Directive (73/ 23/EEC), EMC Directives (89/336/EEC, 92/31/EEC) and CE Marking Directive (93/68/EEC). IMPORTANT CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. CAUTION: TO PREVENT THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. IMPORTANT FOR USE IN THE UNITED KINGDOM The wires in this mains lead are coloured in accordance with the following code : Blue : Neutral Brown : Live If the plug provided is unsuitable for your socket outlets, the plug must be cut off and a suitable plug fitted. The cut-off plug should be disposed of and must not be inserted into any 13 amp socket as this can result in electric shock. [. . . ] Set the BALANCE control to the center position. Load tapes for playback (pre-recorded tape) and recording (blank tape) into the respective cassette decks. Select the copying direction with the INPUT SELECTOR knob and TAPE2 MONITOR button. ÷ When copying from the cassette deck of TAPE1/MD(on the A-307R) or TAPE1/CD-R/MD(on the A-223) terminals to the cassette deck of the TAPE2 MONITOR terminals: Set the INPUT SELECTOR knob to TAPE1/ MD(on the A-307R), TAPE1/CD-R/MD(on the A-223). ÷ When copying from the cassette deck of TAPE2 MONITOR terminals to the cassette deck of TAPE1/MD(on the A-307R), TAPE1/CD-R/MD(on the A-223) terminals: Set the TAPE2 MONITOR button to ON and the INPUT SELECTOR knob to a position other than TAPE1/ MD(on the A-307R), TAPE1/CD-R/MD(on the A-223). PLAYBACK PROCEDURES 1. Set the INPUT SELECTOR knob to the desired playback source. ÷ ÷ ÷ ÷ For playback of a compact disc: Set to [CD]. For reception of an AM/FM broadcast: Set to [TUNER]. For playback of a record: Set to [PHONO]. For playback with the equipment connected to LINE terminals: Set to [LINE]. ÷ For playback of a tape: Set to [TAPE1/MD](on the A307R), TAPE1/CD-R/MD](on the A-223). 3. Operate the cassette decks to begin copying. Set the cassette deck with the original (playback) tape to the playback mode, and set the cassette deck with the blank tape to the recording mode. NOTES: ÷ When you do not want to monitor the TAPE2 MONITOR sound, set the TAPE2 MONITOR button to OFF. ÷ When you select PHONO, the sound is muted for a few seconds. TO USE THE COMPONENT CONNECTED TO THE TAPE2 MONITOR TERMINALS [For a cassette deck] ÷ A cassette deck connected here can be operated in the same way (recording and playback) as a deck connected to the TAPE2 MONITOR terminals. TAPE 1 : For playback with a cassette deck, CD recorder or MD recorder connected to TAPE1/MD(on the A307R) or TAPE1/CD-R/MD(on the A-223) terminals. TAPE 2 : For playback with a cassette deck or adaptor connected to TAPE 2 MONITOR terminals. LINE : For playback with a component connected to the LINE terminal. - STATION + (up), ­ (down) buttons Calls each station number in sequence. = VOLUME + (up), ­ (down) buttons + . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ­ . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Decreases the volume. NOTE: When the accessory remote control unit is used to operate other Pioneer components with the Î mark, it cannot be used to operate functions which do not correspond to the functions listed on the remote control unit. 10 TROUBLESHOOTING Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with this component, check the points below. Sometimes the trouble may lie in another component. Investigate the other components and electrical appliances being used. If the trouble cannot be rectified even after exercising the checks listed below, ask your nearest PIONEER authorized service center or your dealer to carry out repair work. Cause ÷ Power plug is disconnected from outlet. ÷ The amplifier's power plug has been plugged into another component power outlet (e. g. [. . . ] ±8 dB (100 Hz) TREBLE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ±8 dB (10 kHz) Loudness contour (volume control set at ­30 dB position) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +6 dB (100 Hz)/+4 dB (10 kHz) Signal-to-Noise ratio (IHF short circuit, A network) PHONO (MM, 5 mV input) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 85 dB* [A-307R] CD, TUNER, LINE, TAPE1/MD, TAPE2 MONITOR . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]