User manual PIONEER A-X530

[. . . ] Are provided for ventilation and to ensure reliable operation of the product and to protect it from overheating, to prevent fire hazard, the openings should never be blocked and covered with items, such as newspapers, tablecloths, curtains, etc. Also do not put the apparatus on the thick carpet, bed, sofa, or fabric having a thick pile. Any failure due to use for other than household purposes (such as long-term use for business purposes in a restaurant or use in a car or ship) and which requires repair will be charged for even during the warranty period. Operating environment temperature and humidity: +5°C ­ +35°C (+41°F ­ +95°F); less than 85%RH (cooling vents not blocked) Do not install in the following locations · Location exposed to direct sunlight or strong artificial light · Checking what's in the box . [. . . ] Wait about five seconds for your changes to be input automatically. Use the MULTI CONTROL buttons on the remote (or MULTI JOG/INPUT SELECTOR dial on the front panel). 4 Start playback of the component you selected in step 1. If you have connected a decoder or a DVD player with multi-channel analog outputs to this receiver (page 26), you must select the analog multi-channel inputs for surround sound playback. To cancel playback from the multi-channel inputs, use the SIGNAL SEL (SIGNAL SELECT) button to select a different input signal. When playback from the multi-channel inputs is selected, you can't use the INPUT ATT, TONE, and MIDNIGHT/LOUDNESS buttons, as well as the Standard, Advanced Surround, and Stereo/Direct sound modes. When playback from the multi-channel inputs is selected, only the volume and channel levels can be set. To ensure the best possible surround sound, be sure to complete the following set up operations. This is particularly important when using Dolby surround. You only need to make these settings once (unless you change the placement of your current speaker system or add new speakers, etc. Refer to the following pages for details on each of the settings. If you have connected a surround back subwoofer, you should select the surround back subwoofer setting (SB SUBWF) from the options. 1 AUTO), or you can choose to listen to other kinds of sources (for example, 5. 1 encoded sources, a surround back channel will be generated, but the material may sound better in the 5. If you chose SB in Surround back speaker setting (above), you can't set the 6. 1 channel setting affects sound output from the surround back speakers. Default setting: ON You can choose whether the subwoofer is used or not. If you chose the small front speaker setting, SUBWF ON is automatically set and locked. When you select the plus setting, you will get the bass sounds from the subwoofer even if the front speakers are set to L. Default setting: 100 Hz Crossover frequency is the point where the receiver divides the high and low sounds (the frequencies) between the speakers. Since most smaller speakers can't handle deep bass tones, you can send these sounds to the subwoofer (or if you don't have a subwoofer, the large (L) speakers in your system) instead of the speakers set to small (S) in your setup. Choose the point at which you want the frequency routed to the subwoofer (or L speakers). [. . . ] Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with this component, check the points below. Sometimes the trouble may lie in another component. Investigate the other components and electrical appliances being used. [. . . ]