User manual PIONEER AVD-W6210

[. . . ] This product conforms to new cord colors. 5 - When combined with a Pioneer navigation unit Precaution . Read this manual fully and carefully before operating your display. Keep this manual handy for future reference. [. . . ] The marks indicating the current ambient brightness used for adjusting [BRIGHTNESS] and [CONTRAST] may differ slightly. The external light level can be adjusted to Dark, Intermediate or Bright and the each setting saved. To view videos by a VCR, DVD player or a back-up camera connected to the hide-away unit. Each press of the 2 or 3 button selects the source in the following order: [OFF] = [ON] = [BACK-UP CAM] = Exit to [OFF] Note: Using a commercially available back-up camera with the proper setting, this product automatically switches to the back-up camera image when the gear shift is moved to the REVERSE (R) position. For more information, consult your dealer or the nearest authorized Pioneer service facility. This function is designed for use with a back-up camera only. Users may connect the AV IN2 input with "REVERSE-GEAR SIGNAL INPUT" only to a back-up camera. Users must not connect any other devices to the AV IN2 input with "REVERSE-GEAR SIGNAL INPUT". [BATTERY]: When the gear shift is moved to the REVERSE (R) position, and the polarity of the connected lead wire (refer to page 29) is positive. [GND]: When the gear shift is moved to the REVERSE (R) position, and the polarity of the connected lead wire (refer to page 29) is negative. Confirm the safety and get into reverse gear. verify that the back-up camera image appears on the screen when the gear shift is in the REVERSE (R) position. To return to the previous screen, move the gear shift in any position besides REVERSE (R) or just press the NAVI/AV button. Operating temperature range: ­10 to +50 °C Storage temperature range: ­20 to +80 °C At temperatures higher or lower than the operating temperature range, the display may not operate normally. The LCD screen of this product is exposed to improve view ability in the vehicle. Never touch the screen with anything besides your finger when operating the Touch Panel functions. If the display is near the vent of an air conditioner when it is deployed, make sure that air from the air conditioner is not blowing on it. Heat from the heater may break the LCD screen, and cool air from the cooler may cause moisture to form inside the display resulting in possible damage. Also, if the display is cooled down by the cooler, the screen may become dark, or the life span of the small fluorescent tube used inside the display may be shortened. Small black dots or white dots (bright dots) may appear on the LCD screen. These are due to the characteristics of the LCD screen and do not indicate a problem with the display. At low temperatures, the LCD screen may be dark for a while after the power is turned ON. [. . . ] * Where the front of the car is within the driver's field of vision when looking at the display. * Where the display does not protrude above the front of the hood as viewed by the driver. Make temporary connections first to check that the unit and system are working properly. Press the RESET button with the tip of a ball-point pen or similar object, when a connection is completed. [. . . ]