User manual PIONEER AVH-P4000DVD INSTALLATION MANUAL

[. . . ] Do not allow any bare wiring to remain exposed. € Do not drill a hole into the engine compartment to connect the yellow lead of the unit to the vehicle battery. Engine vibration may eventually cause the insulation to fail at the point where the wire passes from the passenger compartment into the engine compartment. Take extra care in securing the wire at this point. [. . . ] When you connect the separately sold multi-channel processor (e. , DEQ-P6600) to this unit, do not connect anything to the speaker leads and system remote control (blue/white). Speaker leads White: White/black: Gray: Gray/black: Green: Green/black: Violet: Violet/black: Front left  Front left  Front right  Front right  Rear left  or subwoofer  Rear left  or subwoofer  Rear right  or subwoofer  Rear right  or subwoofer  6 Connecting the units English Yellow/black If you use equipment with Mute function, wire this lead to the Audio Mute lead on that piece of equipment. If not, keep the Audio Mute lead free of any connections. The position of the parking brake switch depends on the vehicle model. For details, consult the vehicle Owner’s Manual or dealer. Light green Used to detect the ON/OFF status of the parking brake. This lead must be connected to the power supply side of the parking brake switch. The pin position of the ISO connector will differ depending on the type of vehicle. connect 6* and 7* when Pin 5 is an antenna control type. In other types of vehicles, never connect 6* and 7*. notes: · Change the initial setting of this unit (refer to the Operation Manual). The subwoofer output of this unit is monaural. When using a subwoofer of 70 W (2 Ω) , be sure to connect with Violet and Violet/black leads of this unit. Do not connect anything to Green and Green/black leads. 7 Connecting the units When connecting to separately sold power amp This product Power amp (sold separately) Power amp (sold separately) Front output Rear output or subwoofer output Connect with RCA cables (sold separately) Blue/white Connect to system control terminal of the power amp (max. The pin position of the ISO connector will differ depending on the type of vehicle. connect 6* and 7* when Pin 5 is an antenna control type. In other types of vehicles, never connect 6* and 7*. When you connect the separately sold multi-channel processor (e. , DEQ-P6600) to this unit, do not connect anything to the speaker leads and system remote control (blue/white). When you connect the multi-channel processor to this unit, refer to multi-channel processor’s installation manual for the connection method. [. . . ] English Position the unit so that its screw holes are aligned with the screw holes of the bracket, and tighten the screws at 3 or 4 locations on each side. Trim ring Installation using the screw holes on the side of the unit 1. Side bracket If the pawl gets in the way, bend it down. Factory radio mounting bracket Screw for fixing the side bracket (5 × 6 mm) Binding screw or flush surface screw Be sure to use the screws supplied with this unit. [. . . ]