User manual PIONEER AVH-P5000DVD INSTALLATION MANUAL

[. . . ] English Français Español Italiano Deutsch Nederlands PyÒÒÍËÈ MANUEL D’INSTALLATION AVH-P5000DVD INSTALLATION MANUAL Contents Connecting the Units . 7 When connecting with a rear view camera . 9 When connecting with a multi-channel processor . 10 Connecting and installing the optical cable connection box . [. . . ] If not, keep the Audio Mute lead free of any connections. Note: • The position of the parking brake switch depends on the vehicle model. For details, consult the vehicle Owner’s Manual or dealer. Light green Used to detect the ON/OFF status of the parking brake. This lead must be connected to the power supply side of the parking brake switch. The pin position of the ISO connector will differ depending on the type of vehicle. connect 6* and 7* when Pin 5 is an antenna control type. In other types of vehicles, never connect 6* and 7*. Notes: • Change the initial setting of this unit (refer to the Operation Manual). The subwoofer output of this unit is monaural. € When using a subwoofer of 70 W (2 Ω) , be sure to connect with Violet and Violet/black leads of this unit. Do not connect anything to Green and Green/black leads. PyÒÒÍËÈ 6 Connecting the Units When connecting to separately sold power amp This product Rear output or subwoofer output (REAR/SUBWOOFER/DEQ OUTPUT) 15 cm Front output (FRONT OUTPUT) 15 cm Blue/white Connect to system control terminal of the power amp (max. The pin position of the ISO connector will differ depending on the type of vehicle. connect 6* and 7* when Pin 5 is an antenna control type. In other types of vehicles, never connect 6* and 7*. When you connect the separately sold multichannel processor (e. , DEQ-P6600) to this unit, do not connect anything to the speaker leads and system remote control (blue/white). When you connect the multi-channel processor to this unit, refer to multi-channel processor’s installation manual for the connection method. 7 English Power amp (sold separately) Español Power amp (sold separately) Deutsch Connect with RCA cables (sold separately) Français System remote control Left + + Right Front speaker ≠ ≠ Front speaker Italiano Nederlands Rear speaker or subwoofer + ≠ + ≠ Rear speaker or subwoofer Perform these connections when using the optional amplifier. PyÒÒÍËÈ Note: • Change the initial setting of this unit (refer to the Operation Manual). The subwoofer output of this unit is monaural. [. . . ] Connect the optical cable so that it does not protrude from the unit, as shown in the illustration. Fasten the ground lead to the protrusion on the back of the unit. Hook fastener Loop fastener • When installing the optical cable connection box with the lock tie. Wrap the optical cable and connection box with the protection tape and fasten with the power code using the lock tie. [. . . ]