User manual PIONEER AVH-P6400CD annexe 1

[. . . ] If you do, the protection circuit may fail to work properly. This unit is for vehicles with a 12-volt battery and negative grounding. To avoid shorts in the electrical system, be sure to disconnect the battery cable before beginning installation. [. . . ] Please ground this lead separately from the ground of high-current products such as power amps. If you ground the products together and the ground becomes detached, there is a risk of damage to the products or fire. Cords for this product and those for other products may be different colors even if they have the same function. When connecting this product to another product, refer to the supplied Installation manuals of both products and connect cords that have the same function. In this case, be sure to connect 2* to 5* and 4* to 3*. Cap (1*) When not using this terminal, do not remove the cap. Yellow(2*) To terminal always supplied with power regardless of ignition switch position. ISO connector Note: In some vehicles, the ISO connector may be divided into two. In this case, be sure to connect to both connectors. Yellow/black If you use a cellular telephone, connect it via the Audio Mute lead on the cellular telephone. If not, keep the Audio Mute lead free of any connections. In another type of vehicle, never connect 6* and 7*. Subwoofer : Front left + : Front left : Front right + : Front right : Rear left + or Subwoofer + : Rear left or Subwoofer : Rear right + or Subwoofer + : Rear right or Subwoofer Use this for connections when you have the separately available amplifier. When using this product with a back-up camera, automatic switching to VIDEO video when the gear shift is moved to the REVERSE (R) position is possible. When you have completed lead wire connection, perform [VIDEO SETTING] correctly while referring to the Operation Manual. It is necessary to set to [BACK UP CAMERA] in the [VIDEO SETTING] when connecting the back-up camera. Fuse resistor Violet / white Of the two lead wires connected to the back lamp, connect the one in which the voltage changes when the gear shift is in the REVERSE (R) position. This connection enables the unit to sense whether the car is moving forwards or backwards. [. . . ] In this case, stick conceal tape on parts that protrude from the dashboard. Holder After inserting the holder into the dashboard, then select the appropriate tabs according to the thickness of the dashboard material and bend them. (Install as firmly as possible using the top and bottom tabs. [. . . ]