User manual PIONEER AVH-P6400R INSTALLATION MANUAL

[. . . ] 11 1 Note: • This unit is for vehicles with a 12-volt battery and negative grounding. Before installing it in a recreational vehicle, truck, or bus, check the battery voltage. € To avoid shorts in the electrical system, be sure to disconnect the ≠ battery cable before beginning installation. € Refer to the owner’s manual for details on connecting the power amp and other units, then make connections correctly. [. . . ] 1 Connecting the Units Connecting the power cord (1) Note: Depending on the kind of vehicle, the function of 3* and 5* may be different. In this case, be sure to connect 2* to 5* and 4* to 3*. This product 11 cm 5* 4* Connect leads of the same color to each other. Cap (1*) When not using this terminal, do not remove the cap. Yellow (3*) Back-up (or accessory) Yellow(2*) To terminal always supplied with power regardless of ignition switch position. Fuse holder Red (5*) Accessory (or back-up) Fuse resistor Fuse resistor ISO connector Note: In some vehicles, the ISO connector may be divided into two. In this case, be sure to connect to both connectors. Yellow/black If you use a cellular telephone, connect it via the Audio Mute lead on the cellular telephone. If not, keep the Audio Mute lead free of any connections. 3 Subwoofer output or non-fading output (SUBWOOFER OUTPUT or NON-FADING OUTPUT) 15 cm 23 cm ENGLISH Connecting cords with RCA pin plugs (sold separately) Power amp (sold separately) Rear output (REAR OUTPUT) Front output (FRONT OUTPUT) Blue/white To system control terminal of the power amp (max. Power amp (sold separately) Power amp (sold separately) ESPAÑOL DEUTSCH System remote control The pin position of the ISO connector will differ depends on the type of vehicle. connect 6* and 7* when Pin 5 is an antenna control type. In another type of vehicle, never connect 6* and 7*. Left Front speaker Right Front speaker ITALIANO Rear speaker Blue/white (6*) Rear speaker Speaker leads White White/black Gray Gray/black Green Green/black Violet Violet/black Subwoofer : Front left + : Front left ≠ : Front right + : Front right ≠ : Rear left + or Subwoofer + : Rear left ≠ or Subwoofer ≠ : Rear right + or Subwoofer + : Rear right ≠ or Subwoofer ≠ Subwoofer NEDERLANDS Use this for connections when you have the separately available amplifier. Note: Change the Initial Setting of this Product (refer to the Operation Manual). The subwoofer output of this unit is monaural. 2 4 Connecting the Units Connecting the power cord (2) When using this product with a back-up camera, automatic switching to VIDEO video when the gear shift is moved to the REVERSE (R) position is possible. Connect the back-up camera to the VIDEO input. This product Note: • When you have completed lead wire connection, perform [VIDEO SETTING] correctly while referring to the Operation Manual. € It is necessary to set to [BACK UP CAMERA] in the [VIDEO SETTING] when connecting the back-up camera. Power cable Fuse resistor Violet / white Of the two lead wires connected to the back lamp, connect the one in which the voltage changes when the gear shift is in the REVERSE (R) position. This connection enables the unit to sense whether the car is moving forwards or backwards. [. . . ] 11 NEDERLANDS 10 Installation 7 When the installation space is not very deep When installing in a shallow space, secure with side brackets (small). In this case, stick conceal tape on parts that protrude from the dashboard. Holder After inserting the holder into the dashboard, then select the appropriate tabs according to the thickness of the dashboard material and bend them. (Install as firmly as possible using the top and bottom tabs. [. . . ]