User manual PIONEER AVH-P7500DVD INSTALLATION MANUAL

[. . . ] If you do, the protection circuit may fail to work properly. 16 1 Note: • This unit is for vehicles with a 12-volt battery and negative grounding. Before installing it in a recreational vehicle, truck, or bus, check the battery voltage. € To avoid shorts in the electrical system, be sure to disconnect the ≠ battery cable before beginning installation. [. . . ] T T Français Italiano Nederlands 2 Connecting the Units Connecting the system Yellow 40 cm 15 cm 26 pin cable Black Navigation unit (e. A VIC-900DVD) (sold separately) This product 30 pin cable (supplied) Violet 3m Blue IP-BUS input (Blue) 3m Antenna cable (supplied) Violet 3m Hide-away unit (supplied) Antenna jack 21 pin cable (supplied) Blue 10 cm Black Auto-EQ&TA mic jack See the operation manual. 15 cm AV-BUS input (Blue) IP-BUS cable Black IP-BUS cable (supplied with TV tuner) Blue Multi-CD player (sold separately) Hide-away TV tuner (e. 2 3 Connecting the power cord (1) English Hide-away unit Español Deutsch Fuse holder Yellow To terminal always supplied with power regardless of ignition switch position. 3 4 Connecting the Units Connecting the power cord (2) Note: Depending on the kind of vehicle, the function of 3* and 5* may be different. In this case, be sure to connect 2* to 5* and 4* to 3*. 1* 3* 2* This product 5* 4* Connect leads of the same color to each other. Fuse holder Cap (1*) When not using this terminal, do not remove the cap. Yellow (3*) Back-up (or accessory) Yellow (2*) To terminal always supplied with power regardless of ignition switch position. Fuse resistor Red (5*) Accessory (or back-up) Fuse resistor Blue/white (6*) ISO connector Note: In some vehicles, the ISO connector may be divided into two. In this case, be sure to connect to both connectors. The pin position of the ISO connector will differ depending on the type of vehicle. connect 6* and 7* when Pin 5 is an antenna control type. In another type of vehicle, never connect 6* and 7*. Speaker leads White: Front left + White/black: Front left ≠ Gray: Front right + Gray/black: Front right ≠ Green: Rear left + Green/black: Rear left ≠ Violet: Rear right + Violet/black: Rear right ≠ 5 English Violet/white See the section “When connecting with a back-up camera”. Español Yellow/black If you use a cellular telephone, connect it via the Audio Mute lead on the cellular telephone. If not, keep the Audio Mute lead free of any connections. Note: • The position of the parking brake switch depends on the vehicle model. For details, consult the vehicle Owner’s Manual or dealer. Light green Used to detect the ON/OFF status of the parking brake. This lead must be connected to the power supply side of the parking brake switch. 4 6 Connecting the Units When connecting to separately sold power amp Center output (CENTER OUTPUT) 23 cm This product Subwoofer output (SUBWOOFER OUTPUT) 23 cm Rear output (REAR OUTPUT) Noise filter (small) Lock tie 15 cm Front output (FRONT OUTPUT) 15 cm Blue/white To system control terminal of the power amp (max. [. . . ] 9 12 Italiano Nederlands Installation Installing the hide-away unit Mounting with Brackets DIN Front/Rear-mount This unit can be properly installed either from “Front” (conventional DIN Front-mount) or “Rear” (DIN Rearmount installation, utilizing threaded screw holes at the sides of unit chassis). For details, refer to the following illustrated installation methods. Tapping screw (4 × 12 mm) Before installing the unit Screw (4 × 8 mm) • Remove the frame and the holder. 12) Pull out to remove the frame and then loosen the screws (2 × 3 mm) to remove the holder. [. . . ]