User manual PIONEER AVH-Z9100DAB

[. . . ] English AVH-Z9100DAB DVD RDS AV RECEIVER Operation Manual Contents Thank you for buying this Pioneer product. Please read through these instructions so you will know how to operate your model properly. After you have finished reading the instructions, keep this document in a safe place for future reference. Important The screen shown in the examples may differ from actual screens, which may be changed without notice for performance and function improvements. [. . . ] € Immediately verify whether the display changes to the rear view camera image when the gearstick is moved to REVERSE (R) from another position. € When the screen changes to full-screen rear view camera image during normal driving, switch to the opposite setting in [Reverse Gear Setting. € When the camera view of both the rear view camera and 2nd camera are available, the key to switch the display appears. Touch this key to switch the display between the rear view image and 2nd camera image. CAUTION • When adjusting the guidelines, be sure to park the vehicle in a safe place and apply the handbrake. € Before getting out of the car to place the markings, be sure to turn the ignition switch off (ACC OFF). € The range projected by the rear view camera is limited. Also, the vehicle width and distance guidelines displayed on the rear view camera image may differ from the actual vehicle width and distance. ) • The image quality may deteriorate depending on the usage environment, such as at night or in dark surroundings. NOTE Using packing tape or similar tape place markings as shown below before setting up the guidelines so that the guidelines can be overlaid to the markings. menu Item [Camera View] [On] [Off] Description Set to [On] to display camera view at all times. (The same mode is turned on when is touched on the camera view screen. ) NOTES • To set the rear view camera as the camera for Camera View mode, set [Back Camera Input] to [On] (page 42). € When using the second camera, set [AV Input] to [Camera] or [2nd Camera Input] to [On] (both settings are synchronised) (page 42). TIP You can also turn this function on by touching [Camera View] on the AV source selection screen or in the source list. This function is synchronised with [AV Input] setting. Setting the polarity of the rear view camera. The polarity of the connected lead is positive. The polarity of the connected lead is negative. NOTE If the camera polarity setting is wrong, or wrong camera setting is made, press and hold to release the rear view camera screen and then change the camera polarity setting to [Battery]. Markings 25 cm Rear bumper * This setting is available only when you stop your vehicle in a safe place and apply the handbrake. [Wi-Fi Settings] Menu Item [Wi-Fi Settings] Description (page 15) [Parking Assist Guide] [On] [Off] You can set whether to display the parking assist guidelines on the rear view camera images when backing up your vehicle. [. . . ] € The LCD screen will be difficult to see if it is exposed to direct sunlight. € When using a mobile phone, keep the aerial of the mobile phone away from the LCD screen to prevent disruption of the video in the form of disturbances such as spots or coloured stripes. Notice regarding video viewing Remember that use of this system for commercial or public viewing purposes may constitute an infringement on the author’s rights as protected by the Copyright Law. € The product lifetime of the LED backlight is more than 10 000 hours. [. . . ]