User manual PIONEER AVIC-8DVD

[. . . ] € Do not operate the DVD Navigation Unit if doing so will divert your attention from the safe operation of your vehicle. Always observe safe driving rules and follow all existing traffic regulations. € This manual explains how to install this DVD Navigation Unit in your vehicle. Operation of this DVD Navigation Unit is explained in the separate “Operation Manual” or “Hardware Manual” that also came with this unit. [. . . ] When connecting this product to another product, refer to the supplied Installation manuals of both products and connect cords that have the same function. power cord Black To vehicle (metal) body. To keep electromagnetic noise from the vehicle body out of the mobile navigation system, attach this lead near the main unit. Note: When replacing the fuse, be sure to use only a fuse of the rating prescribed on the fuse holder. Note: The yellow, red, and orange/white leads should be connected to the opposite side of the fusebox terminals from the battery. 5 A) Yellow To the terminal always supplied with power regardless of ignition switch position. Fuse resistor Red To the electric terminal controlled by the ignition switch (12 V DC) ON/OFF. Do not connect this lead to power source terminals to which power is continuously supplied. If the lead is connected to such terminals, the battery may be drained. 11 ENG/MASTER 96 12 CRD3803A_inst_001_029_UK 4/1/03 2:22 PM Page 13 Installation CAUTION • Pioneer does not recommend that you install or service your DVD navigation unit yourself. Installing or servicing the product may expose you to risk of electric shock or other hazards. Do not install diagonally to your vehicle’s direction of travel or the current location will be displayed incorrectly. € If you install the left and right sides of the DVD Navigation Unit parallel to your vehicle’s direction of travel, switch the installation direction lever, and attach the locking screw to the “↔” side, or else the G sensor mounted in the DVD Navigation Unit will not operate correctly. Forward / Backward direction of vehicle Front Forward / Backward direction of vehicle Forward / Backward direction of vehicle ENGLISH ESPAÑOL Front Front (Perpendicular) Attachment position of the locking screw ↕ (Parallel) Attachment position of the locking screw ↔ Front Front DEUTSCH FRANÇAIS If you install with the left and right sides of the DVD Navigation Unit parallel to your vehicle’s forward / backward direction If you install with the left and right sides of the DVD Navigation Unit parallel to your vehicle’s forward / backward direction, remove the mounting screw underneath the DVD Navigation Unit, and switch the installation direction lever. Then change the screw mounting position from “↔” side to “↕” side. If the screw is attached to the “↔” side, the G sensor mounted in the DVD Navigation Unit will not operate correctly. Remove the locking screw attached to the installation direction lever. Switch the lever, and attach the mounting screw to the “↔” side. NEDERLANDS Locking screw Underneath the DVD Navigation Unit Locking screw Installation direction lever Installation direction lever 16 17 ENG/MASTER 96 CRD3803A_inst_001_029_UK 4/1/03 2:22 PM Page 18 Installation DIN Front/Rear-mount This unit can be properly installed either from “Front” (conventional DIN Front-mount) or “Rear” (DIN Rear-mount installation, utilising threaded screw holes at the sides of unit chassis). For details, refer to the following illustrated installation methods. DIN Front-mount Installation with the rubber bush After inserting the holder into the dashboard, then select the appropriate tabs according to the thickness of the dashboard material and bend them. (Install as firmly as possible using the top and bottom tabs. [. . . ] Install outer holder on the inner holder and secure with screws. € Tighten the screws with the supplied hexagonal wrench. Install the remote control unit in the holder. € When removing the remote control unit from the holder, move the corrugated release section toward the steering wheel and slide the remote control unit toward you. [. . . ]