User manual PIONEER AVICC-C-9DVD-II

[. . . ] This product conforms to new cord colours. The Pioneer DVD Navigation Unit is intended solely as an aid to you in the operation of your vehicle. It is not a substitute for your attentiveness, judgement and care while driving. Do not use your navigation system to route you to emergency services such as hospitals or police stations. [. . . ] Cords for this product and those for other products may be different colours even if they have the same function. When connecting this product to another product, refer to the supplied Installation manuals of both products and connect cords that have the same function. When combining this navigation unit with a Pioneer car stereo, if the car stereo has yellow/black leads, connect them to those leads. In this way, when the guidance audio is output and when you operate the system by voice, the vehicle stereo is automatically muted to reduce the vehicle stereo volume. This is connected so that the navigation system can detect whether the vehicle is moving forwards or backwards. Connect the purple/white lead to the lead whose voltage changes when the reverse gear is engaged. Unless connected, the sensor may not detect your vehicle travelling forward/backward properly, and thus the position of your vehicle detected by the sensor may be misaligned from the actual position. Note: When you use the ND-PG1 speed pulse generator (sold separately), please make sure to connect it. Check the position of your vehicle's reversing lamp (the one that lights up when the gearstick is in reverse [R]) and find the reversing lamp lead in the boot. Cords for this product and those for other products may be different colours even if they have the same function. When connecting this product to another product, refer to the supplied Installation manuals of both products and connect cords that have the same function. power cord Black To vehicle (metal) body. To keep electromagnetic noise from the vehicle body out of the mobile navigation system, attach this lead near the main unit. Note: When replacing the fuse, be sure to use only a fuse of the rating prescribed on the fuse holder. Note: The yellow, red, and orange/white leads should be connected to the opposite side of the fusebox terminals from the battery. Yellow To the terminal always supplied with power regardless of ignition switch position. Do not connect this lead to power source terminals to which power is continuously supplied. If the lead is connected to such terminals, the battery may be drained. Pioneer does not recommend that you install or service your DVD navigation unit yourself. Installing or servicing the product may expose you to risk of electric shock or other hazards. Refer all installation and servicing of your navigation unit to authorised Pioneer service personnel. Never install the unit in places where: * It could injure the driver or passengers if the vehicle stops suddenly. [. . . ] When attaching the metal sheet, do not cut it into small pieces. Some models use window glass that does not allow signals from GPS satellites to pass through. When installing the aerial outside the vehicle (on the body) Put the GPS aerial in a position as level as possible, such as on the roof or boot lid. When routing the lead in from the top of the door Make a U-shaped loop in the lead on the outside to prevent rainwater from flowing along the lead into the interior of the vehicle. [. . . ]