User manual PIONEER BDR-203BK

[. . . ] Discard warped or cracked discs as they may cause damage to the drive. € 1 – CAUTION This product is a class 1 laser product, but this product contains a laser diode higher than Class 1. To ensure continued safety, do not remove any covers or attempt to gain access to the inside of the product. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ] oVERLOADING - DO NOT overload wall outlets and extension cords. Doing so may result in fire or electric shock. OBJECT AND LIQUID ENTRY - Never push objects of any kind into this product. Touching dangerous voltage points may cause a short resulting in fire or electric shock. Do not spill liquid of any kind on this product. CONDENSATION - Moisture will form in the operating section of the product causing performance to be impaired if it is brought from cool surroundings into a warmer environment. If you are moving the unit to a location with a warmer temperature, let the product stand for 1 to 2 hours in the new location before turning it back on. SERVICING - Do not attempt to repair this product yourself. Opening or removing covers may expose you to dangerous voltage or other hazards. Remove dust or lint from the disc with a soft cloth by wiping from the inside to the outside edge rather than in a circular motion. Do not use record-cleaning or anti-static agents as the solutions may cause damage to a disc. Always be sure to store your discs in proper disc storage cases when not in use, and always be sure to check for dirt or dust on discs (especially on the recording side) before use. 25 inch Half-Height built in type • LCD Tilt Servo Mechanism • Horizontal/Vertical orientation available • Low vibration Mechanism by DRA system Disc Format (Read/Write) • BD-ROM single layer/dual layer • BD-R (Version 1. 1) • DVD single layer/dual layer/120 mm disc/80 mm disc • DVD-R (In case of write, 650 nm disc for General only. 2 (RAM2 Read Only)) (Non-Cartridge) • CD-ROM Mode 1 • CD-ROM XA Mode2 (form 1, form 2) • Photo CD (single and multiple session) • CD-DA • CD-Extra (CD PLUS) • Video CD • CD Text • CD-R • CD-RW, HS CD-RW, US CD-RW, US+ CD-RW Notes: • In order to achieve the specified writing speed, please use the recommended media defined by Pioneer. for more information , consult Pioneer’s website. € Targeted write quality/write speed is not guaranteed when using media deemed of low quality or out of specification. € 4 – INTERFACE FRONT VIEW VUE AVANT INTERFACE SCHNITTSTELLE VORDERANSICHT 1 Loch für erzwungenen Auswurf 1 1 Forced Ejection Hole Insert a stiff rod into the hole and push to eject the tray when the tray doesn’t unload by pressing the Eject button. In the normal operation, the eject button should be used to unload the tray. Make sure the power of the drive is turned off and wait more than one minute till the disc rotation is stopped when access the eject hole. 2 Disc Tray Open the loading tray by pressing the eject button, then place a BD, DVD or CD disc into the slit with the label facing up. Press the eject button to load the tray with the disc. [. . . ] When slide rails are required, please contact your shop or the computer manufacturer. Turn off the power supply of the personal computer. When connecting the power cable from the personal computer, pay close attention to the shape and polarity of the cable. When connecting the Serial ATA interface cable, pay close attention to the shape and polarity of the cable. [. . . ]