User manual PIONEER CD-ML100

[. . . ] Installation or servicing of this product by persons without training and experience in electronic equipment and automotive accessories may be dangerous and could expose you to the risk of electric shock or other hazards. To avoid battery exhaustion Keep the vehicle engine running when using this unit to avoid draining the battery power. Alteration or modifications carried out without appropriate authorization may invalidate the user’s right to operate the equipment. Important • This unit can not be installed in a vehicle that does not have an ACC (accessory) position on the ignition switch. [. . . ] Connect each cable and connector, referring to the connection diagram. After installation, check the connections and the system. 3 4 5 Note If you cannot press RESET after installation, turn the ignition switch to ACC ON followed by ACC OFF and then ACC ON to reset. 1 2 Turn the ignition switch to ACC ON. Press RESET with a pen tip or other pointed instrument. Depending on the type of smartphone that is connected, you may have to perform operations on the smartphone side. You can operate the applications on the touch panel screen as well as on your smartphone screen. Refer to the Pioneer head unit owner’s manual for instructions on how to operate the Pioneer head unit buttons. Before you start ACC position No ACC position • Use of this unit in conditions other than the following could result in fire or malfunction. — Vehicles with a 12-volt battery and negative grounding. €¢ To prevent a short-circuit, overheating or malfunction, be sure to follow the directions below. €” Disconnect the negative terminal of the battery before installation. €” Secure the wiring with cable clamps or adhesive tape. Wrap adhesive tape around wiring that comes into contact with metal parts to protect the wiring. €” Place all cables away from moving parts, such as the shift lever and seat rails. €” Place all cables away from hot places, such as near the heater outlet. €” Do not connect the yellow cable to the battery by passing it through the hole to the engine compartment. €” Cover any disconnected cable connectors with insulating tape. €” Never cut the insulation of the power cable of this unit in order to share the power with other devices. The current capacity of the cable is limited. 2 STAR Precautions IMPORTANT SAFEGUARDS Please read all of these instructions regarding this product and retain them for future reference. 1 Do not install this product where it may (i) obstruct the driver’s vision, (ii) impair the performance of any of the vehicle’s operating systems or safety features, including air bags, hazard lamp buttons or (iii) impair the driver’s ability to safely operate the vehicle. [. . . ] • Avoid exposure to moisture. €¢ Should this unit fail to work properly, please contact your dealer or nearest authorized PIONEER Service Station. Fuse (2 A) Note Refer to the Pioneer head unit owner’s manual for operating instructions for the Pioneer head unit. Power cord (Supplied with Smartphone link adaptor) 2 m (6 ft. [. . . ]