User manual PIONEER CDX-P2050VN annexe 1

[. . . ] Therefore, before playing a CD, turn the volume down all the way then adjust the level by gradually turning the volume up once playback begins. Do not turn the volume up too abruptly as this could damage the speakers. Do not press on the CD loading slot door when it opens or closes. Do not force it open or closed manually. [. . . ] For routine cleaning, wipe the playing surface with a clean, soft, dry cloth from the center of the CD to the outer edge. If the surface is heavily soiled, dampen a clean soft cloth in a solution of mild neutral detergent before cleaning the CD. Do not attempt to play cracked, warped, or otherwise damaged CDs. Playing a bad CD could severely damage the playback mechanism. When not in use, place your CDs in their individual cases and store them in a cool place away from the sun, heat, and dust. Do not grip or pull out the CD while it is being pulled back into the player by the automatic reloading mechanism. When a new CD is inserted into the player, the CD may fail to play after initial loading. This is caused by small bumps around the center hole and outside of CD that prevent proper loading. To remove the bumps, rub the inside edge of the hole and outside edge of the CD with a ball-point pen or other such instrument, then insert the CD again. NOTE: The mechanism automatically prevents a CD with this problem from playing as a protective measure. This is not an indication of faulty operation. The LED flashes green and orange, and this product switches to the CD loading standby mode. In this case, you cannot perform step ¡ to select a CD. when you press the eject button , the currently selected CD is ejected. Also, when you pull a CD out, the door immediately closes. (This unit does not switch to the CD loading standby mode. This product is equipped with two illumination colors, white and orange. you can select the desired illumination color. The illumination color changes each time you press and hold the eject button for 3 seconds or longer. A bracket is attached to this unit to protect it from shocks during shipment. Be sure to remove this bracket before installing this unit in your car (before connecting). Be careful not to injure yourself on the edges or other parts of Caution card the bracket when removing it. [. . . ] SOLUTION Press the eject button, press one of the disc number buttons (1­6), switch the control unit source OFF once, or switch to another source other than CD and then switch back to CD. If performing any of these operations does not cancel the E-01 indication, consult your HONDA dealer. Keep CD clean by using a cleaning kit specifically designed for CDs. Load CD straight and level, not at an angle, CD Changer to prevent further scratching. [. . . ]