User manual PIONEER CLD-S310

[. . . ] Also, rear displays should not be in a location where it is a visible distraction to the driver. In some countries or states the viewing of images on a display inside a vehicle even by persons other than the driver may be illegal. Where such regulations apply, they must be obeyed and this unit's DVD features should not be used. NEVER install the display in a location that enables the driver to watch the DVD or Video CD while driving. ! [. . . ] If seek tuning is performed in 50 kHz steps, stations may be tuned in imprecisely. Tune in the stations with manual tuning or use seek tuning again. Refer to Adjusting initial settings on this page. 2 Press MULTI-CONTROL to select the FM tuning step. Pressing MULTI-CONTROL repeatedly will switch the FM tuning step between 50 kHz and 100 kHz. The selected FM tuning step will appear in the display. Setting the clock Use these instructions to set the clock. 48 En Section Operating this unit 02 Setting the AM tuning step The AM tuning step can be switched between 9 kHz, the preset step, and 10 kHz. When using the tuner in North, Central or South America, reset the tuning step from 9 kHz (531 kHz to 1 602 kHz allowable) to 10 kHz (530 kHz to 1 640 kHz allowable). Refer to Adjusting initial settings on the previous page. 2 Press MULTI-CONTROL to select the AM tuning step. Pressing MULTI-CONTROL repeatedly will switch the AM tuning step between 9 kHz and 10 kHz. The selected AM tuning step will appear in the display. connecting or using auxiliary devices, refer to Using the AUX source on page 53. Operating this unit Switching the auxiliary 1 setting 1 Use MULTI-CONTROL to select AUX1. For details, refer to Switching the auxiliary setting on the previous page. # If AV system display (e. g. , AVX-7650) is combined with this unit, connect the rear view camera to the AV system display. For details concerning connection methods, refer to AV system display's instruction manual. Also, VIDEO IN setting of this unit need not be CAMERA. !After you set up the rear view camera setting, move the gear shift in REVERSE (R) and confirm if a rear view camera video can be shown on the display. If the display should be switched to a rear view camera video by error while you are driving forward, change the rear view camera setting. When you select CAMERA (rear view camera) in VIDEO IN, you can select CAMERA (rear view camera setting). Refer to Adjusting initial settings on page 48. 2 Press MULTI-CONTROL to select an appropriate setting. !BATTERY ­ When the polarity of the connected lead is positive while the gear shift is in REVERSE (R) position !GROUND ­ When the polarity of the connected lead is negative while the gear shift is in REVERSE (R) position Setting the rear output and subwoofer controller This unit's rear output (rear speaker leads output and RCA rear output) can be used for fullrange speaker (FULL) or subwoofer (SUB W) connection. [. . . ] 50/63/80/100/125 Hz Slope . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ­18 dB/oct USB Specification . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . USB 2. 0 full speed Supply current . . . . . . . . . . . . . . . . . . . . . . . . . . 500 mA Maximum amount of memory . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]