User manual PIONEER CLD-V202

[. . . ] Be sure that the power supply voltage of the area where this unit will be used meets the required voltage (e. If the AC plug of this unit does not match the AC outlet you want to use, the plug must be removed and appropriate one fitted. Replacement and mounting of an AC plug on the power supply cord of this unit should be performed only by qualified service personnel. if connected to an AC outlet , the cut-off plug can cause severe electrical shock. [. . . ] The OSD will not appear if you have connected using the HDMI output to your TV. The Auto MCACC Setup will overwrite any existing speaker settings you've made. Before using the Auto MCACC Setup, the iPod USB function should not be selected as an input source. Make sure there are no obstacles between the speakers and the microphone. If you have a tripod, use it to place the microphone so that it's about ear level at your normal listening position. Otherwise, place the microphone at ear level using a table or a chair. Use /// and ENTER on the remote control to navigate through the screens and select menu items. 1 4 Select `Auto MCACC' from the System Setup menu then press ENTER. A progress report is displayed on-screen while the system outputs test tones to determine the speakers present in your setup. Try to be as quiet as possible while it's doing this. For correct speaker settings, do not adjust the volume during the test tones. Be sure to disconnect the microphone from this unit upon completion of the Auto MCACC setup. The settings made in the Auto MCACC Setup should give you excellent surround sound from your system, but it is also possible to adjust these settings manually using the System Setup menu (starting on page 72). Note 1 The subwoofer distance setting may be farther than the actual distance from the listening position. This setting should be accurate (taking delay and room characteristics into account) and generally does not need to be changed. Procedures for listening to audio from a radio or connected other component. On this system, it is possible to switch the input signals for the different inputs as described below. 2 Press SYSTEM to turn on the power of this system. 4 Start playback of the component you selected in step 1. When DIGITAL (C1/O1/O2) or HDMI (H) is selected and the selected audio input is not provided, A (analog) is automatically selected. Each press cycles through the following: · For other inputs, HDMI cannot be selected. 2 When set to DIGITAL or HDMI, 2 lights when a Dolby Digital signal is input, and DTS lights when a DTS signal is input. [. . . ] Set the display volume to minimum when using this configuration. If this doesn't seem to work, try resetting your iPod. IPod/USB Error 1 There is a problem with the signal path from the iPod to the system. IPod/USB Error 2 The software version being used with the Update the software being used with the iPod needs to be updated. [. . . ]