User manual PIONEER CLD-V2120D

[. . . ] Should the fuse need to be replaced, please ensure that the replacement fuse has a rating of 10 amps and that it is approved by ASTA or BSI to BS1362. Check for the ASTA mark or the BSI mark on the body of the fuse. If the plug contains a removable fuse cover, you must ensure that it is refitted when the fuse is replaced. If you lose the fuse cover the plug must not be used until a replacement cover is obtained. A replacement fuse cover can be obtained from your local dealer. [. . . ] OFF ON OFF c 0 to 16 (ms) d Default: 6ms Localizes dialog in the center channel to make it stand DIALOG E out from other background sounds in a TV or movie c OFF/FLAT/UP1/UP2/UP3/ (Dialog Enhancement) soundtrack. By moving from UP1 through UP2 and UP4 d <c> UP3 up to UP4, you can make the sound source seem Default: OFF to relocate upwards. DUAL (Dual Mono) Specifies how dual mono encoded Dolby Digital soundtracks should be played. Dual mono is not widely used, but is sometimes necessary when two languages need to be sent to separate channels. This is useful if you find there is a slight delay before OFF recognizes the PCM signal on a CD, for instance. When ON is selected, noise may be output during playback of non-PCM sources. Please select another input signal if this is a problem. Adjusts the level of dynamic range for movie soundtracks optimized for Dolby Digital, DTS, Dolby Digital Plus, Dolby TrueHD, DTS-HD and DTS-HD Master Audio (you may need to use this feature when listening to surround sound at low volumes). CH1 ­ Channel 1 is heard only CH2 ­ Channel 2 is heard only CH1 CH2 ­ Both channels heard from front speakers OFF ON AUTO MAX MID OFF Switches on/off the effects of Standing Wave Control. For discs created with standards other than Phase Control, the LFE channel is delayed upon recording in the first place. This function corrects for phase shifting on such discs. c UP1 to UP4 can be selected only when the front height speaker is connected. The presence or absence of effects depends on the listening mode. d The initially set AUTO is only available for Dolby TrueHD signals. Select MAX or MID for signals other than Dolby TrueHD. e You shouldn't have any problems using this with most SACD discs, but if the sound distorts, it is best to switch the gain setting back to 0dB. The HDMI Audio setting cannot be switched while performing synchronized amp mode operations. The synchronized amp mode must be turned on in order to play the receiver's HDMI audio and video input signals from the TV with the receiver's power in the standby mode. See About synchronized operations on page 42 . g This feature is only available when the connected display supports the automatic audio/video synchronizing capability (`lipsync') for HDMI. If you find the automatically set delay time unsuitable, set A. DELAY to OFF and adjust the delay time manually. For more details about the lipsync feature of your display, contact the manufacturer directly. [. . . ] 1 Remote control unit . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 AAA size IEC R03 dry cell batteries . . . . . . . . . . . . . . . . . . . . 2 iPod cable . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 AM loop antenna . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]