User manual PIONEER CP81B-K

[. . . ] After you have finished reading the instructions, put them away in a safe place for future reference. This speaker stand can be used only with the following Pioneer speaker systems: S-81B-LR-K, S-81B-LR-QL, or S-81B-LR-W. [. . . ] Before setting up your speaker system, we recommend reading the operating instructions for your system thoroughly. Only use the screws supplied when fixing the speaker to the speaker stand. Do not use with any speaker system other than the one for which the unit was designed. The stand may collapse and be damaged and/or the speaker may fall and cause injury. â· When moving the speaker and stand, first remove the speaker from the stand, and then move the stand, holding it by the stems. â· Place the stand on a stable, level surface; placing the stand on an unstable surface can be dangerous. Align the screw holes on the stand base and speaker support with the screw holes in the three stems, then insert the screws and tighten. If you do not use the spike bases when placing the speakers, the spikes may cause damage to the floor. If you plan on using the spikes we highly recommend to use the spike bases. Note that there are fastening nuts provided on the speaker base (see below). Note that there are fastening nuts provided on the speaker base (see below). Use a polishing cloth or dry cloth to wipe off dust and dirt. â· If the stand is very dirty, use a soft cloth dipped in some neutral cleanser diluted five or six times with water. Never use thinners, benzine, insecticide sprays and other chemicals on or near the stand, since these will corrode the surfaces. [. . . ] â· If the stand is very dirty, use a soft cloth dipped in some neutral cleanser diluted five or six times with water. Never use thinners, benzine, insecticide sprays and other chemicals on or near the stand, since these will corrode the surfaces. [. . . ]