User manual PIONEER CP-F150

[. . . ] When cleaning the surface of the speaker stand bases, gently wipe with the cleaning cloth supplied with the speaker system S-LX70-LR. Wiping with a dusty or hard cloth, or applying too much force when wiping may result in scratching of the surface of the speaker stand base. Those for the CP-F150TS are similar, but of slightly different sizes. These speaker terminals carry HAZARDOUS LIVE voltage. [. . . ] Make sure you assemble the stand on a flat surface that is relatively soft (such as a carpet). The Styrofoam cushions are used during assembly. CP-F150 only: Confirm that the surfaces with printing are facing upwards and oriented as shown, then align the top cushion on the bottom cushion as illustrated. Place the stand on a stable, level surface; placing the stand on an unstable surface can be dangerous. When placing the speaker, keep in mind that the tone is affected by the position of the speaker. If the bass is insufficient, move the speaker closer to the wall. The richest bass sound is obtained when the speaker is right against the wall. If the bass is too powerful, producing a muffled tone, move the speaker away from the wall. Placing the speaker against a thick curtain may also be effective. Adjust the position as necessary to obtain optimal sound from your system. 1 Run the speaker cable through the pillar and place the pillar onto the stand base. Connect the speaker cable with the marking to the (+) terminal, and the cable without the marking to the (­) terminal. If connecting the cords proves to be difficult, slightly move the position of the pillar and speaker. 1 Switch off the power to your amplifier. Finish the installation of the speaker systems in your room by standing them and their attached stands upright. The bottom and top cushioning materials should not be discarded after assembly, but stored in a safe place. When changing the height of the speakers, reassemble the stand while referring to step 3 through 6 of "Assembling the Speaker Stand. " · Do not attempt to adjust the speaker height while the stand is upright. 3 Connect the other ends of the cables to the amp's speaker output terminals (for more details, refer to your amp owner's manual). Grasp the cap knobs on the lower input terminals and rotate them to the left (counter-clockwise), insert the speaker cable wires into the holes in the terminal posts, then tighten the knobs to secure the wires. You can also connect the stand base's terminals with a banana plug. When using a banana plug, be sure to remove the cap at the tip of the input terminal. [. . . ] This may cause the amp to stop functioning, and may even damage the amp. After connecting the plugs, pull lightly on the cables to make sure that the ends of the cables are securely connected to the terminals. Poor connections can create noise and interruptions in the sound. When using a set of speakers connected to an amplifier, you won't be able to obtain the normal stereo effect if the polarity (+ , ­) of one of the speakers (left or right) is reversed. [. . . ]