User manual PIONEER CP-F50

[. . . ] Please read through these operating instructions for proper assembly and use. After you have finished reading the instructions, put them away in a safe place for future reference. [. . . ] The following illustration shows the fully assembled speaker stand: Before setting up your speaker system, we recommend reading the operating instructions for your system thoroughly. Only use the screws supplied when fixing the speaker to the speaker stand. Do not use with any speaker system other than the one for which the unit was designed. The stand may collapse and be damaged and/or the speaker may fall and cause injury. â· When moving the speaker and stand, first remove the speaker from the stand, and then move the stand, holding it by the two stems. Align the screw slots on the stand base and screw holes on the speaker support with the screw holes in the two stems, then insert the screws and tighten. The screw slots allow you to fine-tune the positioning of the speaker. â· If the cabinet or stand is very dirty, use a soft cloth dipped in some neutral cleanser diluted 5 or 6 times with water. Never use thinners, benzine, insecticide sprays and other chemicals on or near the cabinet or stand, since these will corrode the surfaces. Note that these spikes are sharp metal and can cause damage to flooring. Make sure to lay down a cloth or suitable base before setting up. â· The spike bases should be placed as shown below (with the depression on the top side). Make sure to use the spike bases provided to avoid damaging the surface where you place the stand. Specifications and design subject to possible modification without notice, due to improvements. [. . . ] Specifications and design subject to possible modification without notice, due to improvements. â· The product number are listed above in square brackets. [. . . ]