User manual PIONEER CP-ST3

[. . . ] This stand has been designed to support weights up to 1. Exceeding these limits may result in falling or breakage. Front left Center Surround left Surround right Only use the screws supplied when fixing the speaker to the speaker stand. Speakers may fall and incur damages if not fixed in place properly. [. . . ] Do not use with any speaker system other than the one for which the unit was designed. The stand may collapse and be damaged and/or the speaker may fall and cause injury. Be careful when assembling and moving the speaker stand, as it may cause damage or injury in the event of a fall. Make sure you assemble the stand on a flat surface that is relatively soft (such as a carpet). Do not sit or stand on the speaker, or let children play on the speaker. Doing so could provoke the speaker to fall, causing damages or bodily injury. Additional stands will be required if they are used to support surround (rear) speakers as well. Pioneer is not responsible for any accidents or damage that result from improper installation, misuse or modification of the product, or natural disasters. The accompanying illustration shows the fully assembled speaker stand, without speakers or wires. Orient the gasket material with the rear surface of the speaker, and align the screw hole in the angle bracket with the speaker's screw hole, then use the furnished screw (M5xL10) to securely fasten the angle bracket to the speaker. Each arm can mounted facing forward, or pointing 60° to right or left. If a lower speaker unit has an upward-pointing speaker, orient its direction away from the speaker above it. Be sure the speakers are oriented toward the listening position when fastening in place. Align the screw holes in the arm and angle bracket, and use the furnished bind head screws (M4xL8) to fasten securely. Non-skid pads [SEB1343] Screws (Bind head, M4xL12) [BPZ40P120FTB] Screws (Bind head, M4xL8) [BMZ40P080FTB] Polyethylene bag S2 [SHL1295] Polyethylene bag S0 [SHL1314] Polyethylene bag S0 [SHL1329] Polyethylene bag S3 [SHL1429] Polyethylene bag S0 [SHL1438] Polyethylene bag S4 [SHL1457] Polyethylene bag S0 [SHL1478] Protection sheet [SHC1844] After fastening the speakers to the arms, attach each speaker wire to its terminal on the rear of the speaker. use the wire clips to hold the wires in place as required. Protector (Top) [SHA2633] Protector (Bottom) [SHA2634] Packing case [SHG2832] The product numbers are listed above in square brackets. Specifications and design subject to possible modification without notice, due to improvements. If you want to dispose this product, do not mix it with general household waste. There is a separate collection system for used electronic products in accordance with legislation that requires proper treatment, recovery and recycling. [. . . ] There is a separate collection system for used electronic products in accordance with legislation that requires proper treatment, recovery and recycling. Private households in the member states of the EU, in Switzerland and Norway may return their used electronic products free of charge to designated collection facilities or to a retailer (if you purchase a similar new one). For countries not mentioned above, please contact your local authorities for the correct method of disposal. By doing so you will ensure that your disposed product undergoes the necessary treatment, recovery and recycling and thus prevent potential negative effects on the environment and human health. [. . . ]