User manual PIONEER CT-F600

[. . . ] , on the power cord , or pinch the cord. Never make a knot in the cord or tie it with other cords. The power cords should be routed such that they are not likely to be stepped on. A damaged power cord can cause a fire or give you an electrical shock. [. . . ] The recording/playback head should therefore be demagnetized regularly with a commonly sold head demagnetizer. When demagnetizing the head, switch the unit's power ON. To avoid adversely affecting the receiver and speakers, be sure to set the volume level to the minimum. also disconnect the headphone plug from the PHONES jack. For further details, refer to the operating instructions accompanying your head demagnetizer. Tapes recorded using Dolby noise reduction should always be played back with the noise reduction system turned ON. The NR system is turned ON and OFF alternately with each press of the button as shown. : : : Single side play (playback stops after one side) Playback stops after completion of playback in the 2 direction. Continuous repeat playback of both sides, up to a maximum of 16 tape sides, after which the cassette deck stops automatically. Lecture répétée et continue des deux faces jusqu'à un maximum de 16 faces, puis arrêt automatique de la platine-cassette. ¶ Each time the play/direction (2 3) button on the remote control unit is pressed, the direction of travel changes alternately between side A and side B as shown below: 3 (side A) Ô 2 (side B) ¶ When loading the cassette tape in the cassette tray, if the cassette is set with side A facing UP, the "forward" direction (3) will correspond to side A and the "reverse" direction (2) will correspond to side B. Use the 4, ¢ buttons on the CD MD tuner or CD tuner deck to select the track you wish to record (1-track A. ¶ When recording all tracks, do not perform this step. With the CD stopped, confirm that the display shows the total number of tracks. If the total number of tracks is not displayed, press the stop (7) button on the CD MD tuner or CD tuner deck. ¶ When this procedure is used to select a CD track, the One-Track A. ¶ CDs and cassette tapes cannot be removed during A. Recording can also be stopped by pressing the stop (7) button on the CD MD tuner or CD tuner deck. NOTES: ¶ When the tape cassette comes to the end of side A and recording switches to side B, if CD playback is in the middle of a track, that entire track will be recorded anew on side B. If the CD player's repeat function is turned ON, repeat playback will be canceled. Function to play back a cassette tape on the CD tuner deck while automatically recording onto another cassette tape. Insert the cassette tape which you wish to record onto. [. . . ] nOTES: ¶ Following timer recording , the sound volume automatically remains set at "0". ¶ If the TIMER button is pressed when the power is set to off (standby), the current timer setting contents can be checked. This function can be used when the system cable is used to connect this unit to the XC-IS21MD or XC-IS21T. By using the timer function on the CD Tuner Deck or CD MD Tuner, automatic wake-up timer playback can be performed on this unit. [. . . ]