User manual PIONEER CT-J500WR

[. . . ] 2 Keep this manual handy as a reference for operating procedures and safety information. 3 Pay close attention to all warnings in this manual and follow the instructions carefully. 4 Do not allow other persons to use this system until they have read and understood the operating instructions. 5 Do not install the display where it may (i) obstruct the driver's vision, (ii) impair the performance of any of the vehicle's operating systems or safety features, including air bags, hazard lamp buttons or (iii) impair the driver's ability to safely operate the vehicle. [. . . ] 2 Touch Dolby Pro Logic II. 13 Setting the speaker setting Be sure to adjust the speaker settings, such as size (bass capacity), according to the speakers installed. Set the size to Large (large) if the speaker is capable of reproducing sounds of about 100 Hz and below. Low frequency sound is not emitted if the subwoofer is set to Off and the front and rear speakers are set to Small or Off. It is imperative that speakers that are not installed be set to Off. Set the front or rear speaker to Large if the speaker is capable of reproducing bass content, or if no subwoofer is installed. Refer to Introduction of menu operations on page 44. 2 Touch Speaker Setting. Menu operations 3 Touch Music and then touch Music Adjust. # You can only operate Music Adjust when Music has been selected. 4 Touch a or b to select Panorama (panorama). Panorama (panorama)--Dimension (dimension)--Center Width (center width) 5 # To turn panorama control off, touch c. 3 Touch a or b to select the speaker to be adjusted. Front (front speakers)--Center (center speaker)--Rear (rear speakers)--Subwoofer (subwoofer)--Phase (subwoofer setting) # You can only switch to Phase when the subwoofer has been set to On. Touch d to turn panorama control on. 6 Touch b to select Dimension and then touch c or d to adjust the front/rear speaker balance. Range: +3 to ­3 7 Touch b to select Center Width and then touch c or d to adjust the center image. Range: 0 to 7 The default setting is 3 and is recommended for most recordings. (low-pass filter) and the Small speaker's H. P. F. The cross-over frequency setting has no effect if the subwoofer is set to Off and other speakers are set to Large or Off. If necessary, select speakers and adjust their `absolute' output levels. (Refer to Adjusting the speaker output levels on the previous page. ) !You will get the same results whether you adjust the speaker output levels with this mode or with Speaker Level. 13 Menu operations Adjusting the speaker output levels using a test tone You can easily get the right overall balance among the speakers with this function. Refer to Introduction of menu operations on page 44. 2 Touch Test Tone. Using time alignment The distance between the listening position and each speaker can be adjusted with this function. Refer to Introduction of menu operations on page 44. 2 Touch Time Alignment. 3 Touch Start to start test tone output. The test tone is emitted from each speaker in the following sequence at intervals of about two seconds. The current settings for the speaker emitting the test tone will be shown on the display. [. . . ] 8. 2 and earlier) DivX decoding format . . . . . . . . . . . . 3, 4, 5. 2, 6 (. avi, . divx) SD Compatible physical format . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Version 1. 10 File system . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . FAT12, FAT16, FAT32 MP3 decoding format . . . . . . . . . . . [. . . ]