User manual PIONEER CT-W204

[. . . ] Also, rear displays should not be in a location where they are visibly distracting to the driver. In some countries or states the viewing of images on a display inside a vehicle even by persons other than the driver may be illegal. Where such regulations apply, they must be obeyed and this unit's DVD features should not be used. NEVER install the display in a location that enables the driver to watch the DVD or Video CD while driving. 01 These symbols on the products, packaging, and/or accompanying documents mean that used electrical and electronic products and batteries should not be mixed with general household waste. [. . . ] 1 Move the thumb pad up or down to select PARENTAL in GEN. Parental lock setting menu is displayed. 42 En Section Operating this unit 3 Press 0 to 9 to input a four digit code number. 4 Move the thumb pad left or right to move the cursor to the previous or next position. 5 Click the thumb pad after entering the four digit code number. The code number is set, and you can now set the level. 6 Move the thumb pad left or right to select the desired level. !LEVEL8 ­ Playback of the entire disc is possible (initial setting) !LEVEL7 to LEVEL2 ­ Playback of discs for children and non-adult-oriented discs is possible !LEVEL1 ­ Playback of discs for children only is possible 02 4 Move the thumb pad left or right to move the cursor to the previous or next position. 5 Click the thumb pad after entering the four digit code number. This enters the code number, and you can now change the level. # If you input an incorrect code number, the icon is displayed. If more than 126 characters are set, the excess characters will not be displayed. Make a note of the code as you will need it when you register with a DivX VOD provider. # Pressing RETURN takes you back to the previous display. Setting the down sampling output If the sampling frequency of the audio is more than 96 kHz, the audio outputted from the digital output of this unit can be reduced to 48 kHz. Normally, set the down sampling output to on. If this unit's digital output is not used, there is no need to change settings. 1 Move the thumb pad up or down to select SAMPLING OUTPUT in GEN. Each time you click the thumb pad the selected setting switches on or off. # Pressing RETURN takes you back to the previous display. Setting for digital output Audio which is outputted from digital output of this unit can be selected. If this unit's digital output is not used, there is no need to change settings. Selecting Linear PCM enables you to switch the output channel if playing the following type of discs. (Refer to Selecting audio output on page 28. ) -- Dual mono mode DVD video discs -- Bilingual DVD-VR discs 1 Move the thumb pad up or down to select IEC DIGITAL OUTPUT in GEN. 2 Click the thumb pad to select the desired digital output setting. ! [. . . ] 10 kHz Gain . . . . . . . . . . . . . . . . . . . . . . . . . . . . ±12 dB FM tuner Frequency range . . . . . . . . . . . . . . . . . . . . . . 87. 5 MHz to 108. 0 MHz Usable sensitivity . . . . . . . . . . . . . . . . . . . . . 9 dBf (0. 7 µV/75 W, mono, S/N: 30 dB) Signal-to-noise ratio . . . . . . . . . . . . . . . [. . . ]