User manual PIONEER CT-W710R

[. . . ] To prevent fire hazard, the openings should never be blocked or covered with items (such as newspapers, table-cloths, curtains) or by operating the D3-4-2-1-7b_A_En equipment on thick carpet or a bed. To prevent a fire hazard, do not place any naked flame sources (such as a lighted candle) on the D3-4-2-1-7a_A_En equipment. Operating environment temperature and humidity: +5 ºC to +35 ºC (+41 ºF to +95 ºF); less than 85 %RH (cooling vents not blocked) Do not install this unit in a poorly ventilated area, or in locations exposed to high humidity or direct sunlight (or D3-4-2-1-7c_A_En strong artificial light) Before plugging in for the first time, read the following section carefully. The voltage of the available power supply differs according to country or region. [. . . ] ⷠConnect the power cord to the AC inlet (AC IN) on the rear panel of the tuner, then plug into a AC outlet. Liquid Crystal Display The LCD used in this unit has a tendency to change color in response to the surrounding temperature. The display's color tone may turn gray or its ability to switch between displayed information may slow down when the room is not at optimum temperature, or when the unit has been operating for a long period of time. However, these are only temporary symptoms and regular functionality will be restored once the unit returns to optimum temperature. 4 RDS indicator Lights when an RDS broadcast is received, and flashes during RDS search. Goes off when a monaural broadcast is received. Lights blue when the MPX mono mode is selected. Remember that even when the unit is in the standby mode, it remains connected to the AC line voltage. Be sure to unplug the power cord whenever leaving your home for vacations or when otherwise not using the unit for extended periods of time. ⷠWhen the unit is in the standby mode, if the power is turned off by pressing the main unit's POWER button, the power will not turn on if the button is pressed again. To turn on the power in this case, press either the remote control unit's button or a different button (other than the POWER button) on the main unit. If a station cannot be preset automatically due to poor reception, use the "Manual tuning" operation to tune in the station, then preset it using the manual "Preset stations" operation. Perform this operation from the remote control unit. 1 Make sure that the unit is in standby mode, and then press the button to turn on the power. When the first broadcast station is found, that station is stored in the preset memory at channel A1. Subsequent stations are automatically stored in order at preset channels A1 to A10, B1 to B10, C1 to C10, D1 to D10, E1 to E10, F1 to F10, G1 to G10, H1 to H10, I1 to I10 and J1 to J10 for a maximum of 100 stations. ⷠChannel A1 is tuned in after the auto preset memory operation is completed. 4 Either turn the TUNING/PRESET dial or press the ST + or ST ­ button to select the search mode. The frequency changes continuously when the TUNE + or TUNE ­ button on the remote control unit is held in. ⷠWhen the MPX mono mode has been selected, FM stereo broadcasts will be received in monaural, and the STEREO indicator will light blue. 4 Either turn the TUNING/PRESET dial or press the ST + or ST ­ button to select the search mode. Automatic searching will begin, and then stop when a station is received. [. . . ] When you use a remote control, the control signal is passed along the chain to the appropriate component. Note that if you use this feature, make sure that you also have at least one set of analog audio jacks connected to another component for grounding purposes. 1 Connect the CONTROL IN jack of this tuner to the CONTROL OUT jack of your Pioneer amplifier. Use a cable with a mono mini-plug on each end for the connection. [. . . ]