User manual PIONEER CT-X350W

[. . . ] However the method of connecting and operating the unit is the same. RISK OF ELECTRIC SHOCK DO NOT OPEN The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. Do not pull out the plug by tugging the cord and never touch the power cord when your hands are wet as this could cause a short circuit or electric shock. Do not place the unit, a piece of furniture, etc. [. . . ] When only the L channel is connected, the input in the L channel will be input into the R channel. Connect to AC outlet plug with the provided power cord. Before making or changing connections, switch off the power and disconnect the power cord from the AC outlet. When all other connections are completed, connect the supplied power cord to the AC inlet located on the rear panel of this unit, and connect the power plug to an AC outlet or auxiliary power socket on an amplifier. Be sure to use only the supplied power cord. When using digital connections, connect the digital coaxial output connector to one of the DIGITAL input connectors of the DJM1000, and switch the input selector switch of the connected channel to [DIGITAL] (no digital input connectors are provided for channel 1 and channel 2). Other line level output devices 3 mm phone plug, connect to one of the LINE input connectors of the CT-X350W, and switch the input selector switch of the connected channel to [LINE] (no LINE input connectors are provided for channel 5 and channel 6). DJ CD player DJ CD player When using digital connections to devices such as CD players, connect the device's digital coaxial output connector to one of the DIGITAL input connectors of the CT-X350W, and switch the input selector switch of the connected channel to [DIGITAL] (no DIGITAL input connectors are provided for channel 1 and channel 2). 3 mm phone plugs to connect the DJ mixer's SEND connectors to the input connectors of an external effector. When using a monaural input effector, connect only the L channel output. in this way , the mixed L/R audio signal will be sent to the effector. The isolator function operates with respect to master output 1, master output 2, booth monitor output, recording output and digital output. Use to adjust the high-range sound of the master output signal. Used to adjust the mid-range sound of the master output signal. Used to adjust the low-range sound of the master output signal. Used to adjust the high-range sound of the booth monitor output signal. Used to adjust the low-range sound of the booth monitor output signal. When a digital link cable (mini DIN connector) is used to connect this unit to a PIONEER DJ effector with digital link support (EFX-1000), setting these buttons to ON enables fader effect functions. The indicator lights when the function is turned ON. When the CROSS FADER ASSIGN switches for each channel are used to select [A] or [B], the cross fader start/ stop function of that channel's DJ CD player are turned ON/ OFF. When [THRU] is selected by the CROSS FADER ASSIGN switch for each channel, the channel fader start/stop function for that channel's DJ CD player is turned ON/OFF. The button for each channel lights up when the fader start/ stop function is turned ON, and is turned off when the fader start/stop function is turned OFF. [. . . ] A digital link cable can be used to connect a digital link DJ CD player to the SOUND 1, 2 connectors of this unit. This link provides a high-fidelity digital connection for mixing of sounds from the DJ CD player. The fader start function is also enabled by means of this single digital link. When a digital link cable is used to connect a supported DJ CD player to the SOUND 1, 2 connectors, and the DJ effector EFX1000 is connected via digital link cable to the EFX 1 or 2 connectors, the effects can be added at the more accurate BPM value measured with the DJ CD player. [. . . ]