User manual PIONEER CT-Z470WR

[. . . ] 2 Keep this manual handy as a reference for operating procedures and safety information. 3 Pay close attention to all warnings in this manual and follow the instructions carefully. 4 Do not allow other persons to use this system until they have read and understood the operating instructions. 5 Do not install the display where it may (i) obstruct the driver's vision, (ii) impair the performance of any of the vehicle's operating systems or safety features, including air bags, hazard lamp buttons or (iii) impair the driver's ability to safely operate the vehicle. [. . . ] Set the front or rear speaker to Large if the speaker is capable of reproducing bass content, or if no subwoofer is installed. Refer to Introduction of menu operations on page 45. 2 Touch Speaker Setting. 3 Touch Music and then touch Music Adjust. # You can only operate Music Adjust when Music has been selected. 4 Touch a or b to select Panorama (panorama). Panorama (panorama)--Dimension (dimension)--Center Width (center width) 5 # To turn panorama control off, touch c. 3 Touch a or b to select the speaker to be adjusted. Front (front speakers)--Center (center speaker)--Rear (rear speakers)--Subwoofer (subwoofer)--Phase (subwoofer setting) # You can only switch to Phase when the subwoofer has been set to On. Touch d to turn panorama control on. 6 Touch b to select Dimension and then touch c or d to adjust the front/rear speaker balance. Range: +3 to -3 7 Touch b to select Center Width and then touch c or d to adjust the center image. Range: 0 to 7 The default setting is 3 and is recommended for most recordings. When set to 0, all center sound is placed in the center speaker. When set to 7, center sound is equally placed in the left and right speakers. 4 Touch c or d to select the correct size for the selected speaker. Off (off)--Small (small)--Large (large) # You cannot select Off when Front (front speakers) has been selected. # You can select On or Off when Subwoofer (subwoofer) has been selected. You will get the same results whether you adjust the speaker output levels with this mode or with Speaker Level. Adjusting the speaker output levels using a test tone You can easily get the right overall balance among the speakers with this function. Refer to Introduction of menu operations on page 45. 2 Touch Test Tone. Using time alignment The distance between the listening position and each speaker can be adjusted with this function. Refer to Introduction of menu operations on page 45. 2 Touch Time Alignment. 3 Touch Start to start test tone output. The test tone is emitted from each speaker in the following sequence at intervals of about two seconds. The current settings for the speaker emitting the test tone will be shown on the display. Front-L (left front speaker)--Center (center speaker)--Front-R (right front speaker)-- Rear-R (right rear speaker)--Rear-L (left rear speaker)--Subwoofer (subwoofer) Check each speaker output level. If no adjustments are needed, perform step 5 to stop the test tone. # The settings for speakers with the size set to Off will not be displayed. (Refer to Setting the speaker setting on page 52. ) 3 Touch any of the following touch panel keys to select the time alignment. !Initial ­ Initial time alignment (factory setting) ! [. . . ] 3, 4, 5. 2, 6 (. avi, . divx) SD Compatible physical format . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Version 1. 10 Maximum memory capacity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 GB File system . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . FAT12, FAT16, FAT32 MP3 decoding format . . . . . . . . . . . [. . . ]