User manual PIONEER CT-Z570WR

[. . . ] If the vehicle is equipped with a glass antenna, connect it to the antenna booster power supply terminal. Never connect blue/white cable to external power amp's power terminal. Also, never connect it to the power terminal of the auto antenna. Otherwise, battery drain or malfunction may result. [. . . ] Do not allow any bare wiring to remain exposed. Do not drill a hole into the engine compartment to connect the yellow lead of the unit to the vehicle battery. Engine vibration may eventually cause the insulation to fail at the point where the wire passes from the passenger compartment into the engine compartment. Take extra care in securing the wire at this point. It is extremely dangerous to allow the display lead to become wound around the steering column or gearshift. Be sure to install the display in such a way that it will not obstruct driving. Make sure that wires will not interfere with moving parts of the vehicle, such as the gearshift, parking brake or seat sliding mechanism. If you do, the protection circuit may fail to work properly. Cap (1*) Do not remove cap if this terminal is not in use. Yellow/black If you use an equipment with Mute function, wire this lead to the Audio Mute lead on that equipment. If not, keep the Audio Mute lead free of any connections. When you connect separately sold multi-channel processor (e. DEQ-P6600) to this unit, do not connect anything to the speaker leads and system remote control (blue/white). Rear speaker Note: When you connect multi-channel processor to this unit, separately sold power amp must be connected to multi-channel processor. Fasten with the lock tie Screw Perform these connections when using the optional amplifier. Never install the display in a location where it is visible to the driver while driving. It is necessary to set VIDEO IN to EXT-VIDEO in initial settings when connecting the external video component. The use of unauthorized parts may cause malfunctions. Consult with your dealer if installation requires drilling of holes or other modifications of the vehicle. Do not install this unit where: -- it may interfere with operation of the vehicle. -- it may cause injury to a passenger as a result of a sudden stop. the semiconductor laser will be damaged if it overheats. [. . . ] When reattaching the trim ring, push the trim ring onto the unit until it clicks. (If the trim ring is attached upside down, the trim ring will not fit properly. ) · It becomes easy to remove the trim ring if the front panel is released. When reattaching the trim ring, push the trim ring onto the unit until it clicks. [. . . ]