User manual PIONEER CX-7000

[. . . ] In some countries or regions, the shape of the power plug and power outlet may sometimes differ from that shown in the explanatory drawings. However the method of connecting and operating the unit is the same. RISK OF ELECTRIC SHOCK DO NOT OPEN The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. Replacement and mounting of an AC plug on the power supply cord of this unit should be performed only by qualified service personnel. [. . . ] When this unit's power is on, press [u] 1 for at least 2 seconds. When [u] is pressed again, the power turns on. This unit is equipped with an auto standby function. Check that this unit is properly connected to the DJ player, etc. Note that very loud sounds will be output if the volume is set too high. To output the sound of channel 2 ([CH-2]) 2, perform the procedure below replacing [CH-1] with [CH-2]. Select the input source for [CH-1] from among the devices connected to this unit. The [CH-1] channel level indicator f lights when audio signals are being properly input to [CH-1]. Adjust [TRIM] so that the orange indicator lights at the point in the track where the volume is loudest (the climax, etc. Be careful that the red indicator does not light, or the sound could be distorted. Move the [CH-1] 1 channel fader g to the back side. This adjusts the balance of the monitor volume between the sound output from the [MASTER OUT 1, 2] terminals (the sound of [CH-1]) and the sound of [CH-2]. While checking the sound over the headphones, adjust the tempo of [CH-2] track to match the tempo of [CH-1] track. If you set the crossfader back to the original position, the player instantaneously returns to the cue point already set and pauses playback (back cue). 7 While moving the [CH-2] 2 channel fader to the back, move the [CH-1] 1 channel fader to the front. While checking the sound output from the speakers, operate the channel faders to substitute the sound of [CH-1] with the sound of [CH-2]. Mixing is completed once only the [CH-2] sound is being output from the speakers. When a button that is flashing is pressed again, the effect is turned off. Cut from the sound of the Right: The low range (bass track's rhythm section to drum, etc. Left: The sound is crushed and an effect as if the high range was gradually cut is achieved. Right: The sound is crushed and an effect as if the low range was gradually cut is achieved. Right: An effect as if the low range was gradually cut is achieved. [. . . ] Not enough free space on the USB device. Use a USB device formatted with a file system supported by this unit (FAT or HFS+). Use a USB device with sufficient free space. Files created through recording are given a 3-digit number. [. . . ]