User manual PIONEER CX-J310

[. . . ] Never make a knot in the cord or tie it with other cords. The power cords should be routed such that they are not likely to be stepped on. A damaged power cord can cause a fire or give you an electrical shock. When you find it damaged, ask your nearest PIONEER authorized service center or your dealer for a replacement. [. . . ] This product allows you to use a single set of speakers for all your music needs, from DJ performances to production, and ordinary music enjoyment. Audio response can be adjusted to perfectly match all situations, from DJ performances to production and ordinary music enjoyment. Frequently used controls such as sound LEVEL, MUTE ON/OFF, Power ON/Standby, EQ ON/OFF and source INPUT can be set with the hand-held controller simultaneously for both right and left speakers. Power cords (2) Link cable (1) Controller (1) Rubber feet (8) !A speaker's playback sound is delicately influenced by conditions in the listening room. To produce optimum listening conditions, take due consideration of the conditions of your installation location before beginning actual installation. To promote proper cooling, please assure that sufficient space is preserved between the speakers and nearby walls or other components (minimum 30 cm or more above, behind, and to right and left sides of each speaker). Leaving insufficient space between the speaker and walls or other components may lead to rising interior temperatures, leading to malfunction or damage. For natural stereo effect, the right and left speakers should be installed in symmetrical and equidistant positions from the listening position. Speakers should ideally be located at 30° angles from the listening position (together forming a total 60° angle), and rotated inward to face the listening position. To promote proper cooling, speakers should be separated 30 cm or more from walls. As a fire-prevention measure, the product should be installed within easy reach of its power outlet so that the power plug can be disconnected whenever you go on a trip or are otherwise not using the unit for an extended period of time. This dial functions only when the EQ ON/OFF button is set to ON. This dial functions only when the EQ ON/OFF button is set to ON. Each time button is pressed, the input alternates in the order INPUT 1d 2 d 3 d 4. Use to switch unit between power ON and Standby modes. When the button is pressed, power is turned on; when the button is pressed again, the unit enters the standby mode. This dial operates when no controller is connected. Unbalanced-type cables with phone plugs can also be used, but the volume of sound will be reduced. When you desire higher volumes of sound, use a balanced cable equipped with a TRS phone plug. Use to turn the power-save function ON/OFF. Connect the accessory power cord here and to an AC power outlet. [. . . ] In this case, lower the output level of the device. If the equalizer control is adjusted toward the "+" side while the sound volume is raised, distortion may occur. In this event, lower the sound volume, or adjust the equalizer to a level that does not cause distortion. This unit is equipped with a self-resetting protection circuit. [. . . ]