User manual PIONEER CX-J710

[. . . ] To prevent a fire hazard, do not place any naked flame sources (such as a lighted candle) on the equipment. Operating environment temperature and humidity:+5 °C to +35 °C (+41 °F to +95 °F); less than 85 %RH (cooling vents not blocked) Do not install this unit in a poorly ventilated area, or in locations exposed to high humidity or direct sunlight (or strong artificial light) This speaker system is cannot be used nearby a CRT-based TV or color monitor. When using this kind of CRT-based TV or color monitor, install the speakers away from the display device. Any other device liable to be influenced by magnetism (floppy disk drive, cassette tape recorder, video tape player, etc. [. . . ] To avoid fire hazard, the AC adapter should also be unplugged from the AC outlet when left unused for a long period of time (for example, when on vacation). Any failure due to use for other than household purposes (such as long-term use for business purposes in a restaurant or use in a car or ship) and which requires period. Thank you for buying this Pioneer product. Please read through these operating instructions so that you will know how to operate your model properly. After you have finished reading the instructions, put them in a safe place for future reference. The first thing to do is unpack the CX-J710 package and make sure it includes all of the following contents: · Slide the power plug along the guide rails of the AC adapter as shown in the figure below until there is an audible click. Once you've found where you'd like to put the CX-J710, you have two placement options: Standitup: The CX-J710 comes with removable legs for upright placement on a flat surface. Simply attach the legs to the back of the CX-J710 to leave the unit in this position (see below for details). Hangitonthewall: The back of the CX-J710 has two mounting holes that fit over screws of article on the market (refer to page 7). Position one of the legs over one of the recessed areas on the back of the CX-J710 as shown. Insert the leg into the recessed area and press upward to lock it in place. vOLUME­/+Turns the CX-J710 volume down or up. (Skipback)Goes to the previous track (or to the beginning of the song currently playing) in the current playlist on your docked iPod. (Skipforward)Goes to the following track in the current playlist on your docked iPod. The remote control that came with the CX-J710 can operate the functions of an iPod that is docked. Make sure to replace only with the same or equivalent type recommended by the manufacturer. Do not disassemble, heat above 100 °C, or incinerate. Whendisposingofusedbatteries, pleasecomplywithgovernmental regulations or environmental public instruction's rules that apply in your country / area. wARNING · Donotuseorstorebatteriesindirectsunlightorotherexcessively hot place, such as inside a car or near a heater. This can cause batteries to leak, overheat, explode or catch fire. It can also reduce the life or performance of batteries. Also brings a docked iPod out of sleep mode when the CX-J710 turns on. [. . . ] iPodDoesNotConnecttoSpeakerSystem · RemoveiPodfromthedockandconfirmthatyouareusingthe appropriate insert for the model of iPod you have. Pressthepowerbuttonon the CX-J710 front panel if the front panel is not illuminated. If there still is no sound, remove the iPod from the docking port, turn the CX-J710 off, unplug the unit from the wall outlet, wait one to two minutes, and then plug the AC adapter back into the wall outlet, turn the CX-J710 back on, put your iPod into the dock, and try the above steps again. Remove the iPod from the docking port and reattach it, making sure that there is a secure fit between the iPod and the docking port. [. . . ]