Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual PIONEER DC-J210. We hope that this PIONEER DC-J210 user guide will be useful to you.
Lastmanuals help download the user guide PIONEER DC-J210.
Detailed instructions for use are in the User's Guide.
[. . . ] 2 Keep this manual handy as a reference for operating procedures and safety information. 3 Pay close attention to all warnings in this manual and follow the instructions carefully. 4 Do not allow other persons to use this system until they have read and understood the operating instructions. 5 Do not install the display where it may (i) obstruct the driver's vision, (ii) impair the performance of any of the vehicle's operating systems or safety features, including air bags, hazard lamp buttons or (iii) impair the driver's ability to safely operate the vehicle. [. . . ] Adjustment Enables adjusting the time alignment as desired !Off Turns Time Alignment off # You cannot select Auto TA if auto TA and EQ have not been carried out. # Adjustment can only be selected when either Front-L or Front-R is selected in Position.
4 Touch c or d to adjust the speaker output level. Range: +10 to 10
# The test tone will be emitted from the next speaker after about two seconds after the last operation.
Adjusting time alignment
The distance between the selected position and each speaker can be adjusted. The adjusted time alignment is stored in Custom.
5
Touch Stop to end test tone output.
En
55
Section
13
Menu operations
1 Display the DSP function menu. Refer to Introduction of menu operations on page 46. 2 Touch Time Alignment and then touch Adjustment.
# Adjustment can only be selected when either Front-L or Front-R is selected in Position.
!The equalizer curves for Custom1 and Custom2 can be adjusted. When Flat, no changes are made to the sound. You can check the effects of the equalizer curves by switching alternatively between Flat and another equalizer curve. When Digital Direct is on, the equalizer curve is fixed to Flat. 40Hz--50Hz--63Hz--80Hz--100Hz--125Hz --160Hz--200Hz--250Hz--315Hz--400Hz --500Hz--630Hz--800Hz--1kHz--1. 25kHz --1. 6kHz--2kHz--2. 5kHz--3. 15kHz--4kHz --5kHz--6. 3kHz--8kHz--10kHz--12. 5kHz 8 Touch b and then touch c or d to adjust the equalizer level. Range: +12 to 12 9 Touch b and then touch c or d to select the desired Q factor. Narrow (narrow)--Wide (wide)
# Adjust the parameters of each band for the other speakers in the same way. Note A center frequency can be selected for each band and can be changed in 1/3-octave steps. However, the interval between the selected center frequencies cannot be shorter than 1 octave.
Auto TA and EQ (auto-time alignment and auto-equalizing)
Auto-time alignment automatically adjusts the time alignment according to the distance between the listening position and each speaker. The auto-equalizer automatically measures the car's interior acoustic characteristics, and then creates an auto-equalizer curve based on that information.
WARNING
As a loud tone (noise) may be emitted from the speakers when measuring the car's interior acoustic characteristics, never perform auto TA or auto EQ while driving.
CAUTION
!Thoroughly check the conditions before performing auto TA and EQ as the speakers may be damaged if these functions are performed when: -- The speakers are incorrectly connected. (For example, when a rear speaker is connected as a subwoofer output. ) -- A speaker is connected to a power amp delivering output higher than the speaker's maximum input power capability.
En
57
Section
13
Menu operations
!If the microphone is placed in an unsuitable position the measurement tone may become loud and measurement may take a long time, resulting in battery drainage. Be sure to place the microphone in the specified location.
Before operating the auto TA and EQ function
!Perform auto TA and EQ in a quiet place, with both the car engine and air conditioning switched off. [. . . ] 7, 7. 1, 8, 9, 10, 11 (2ch audio) (Windows Media Player)
108
En
Appendix
Additional Information
AAC decoding format . . . . . . . . . . . . 8. 2 and earlier) DivX decoding format . . . . . . . . . . . . 3, 4, 5. 2, 6 (. avi, . divx)
SD
Compatible physical format . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Version 1. 10 File system . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE PIONEER DC-J210
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual PIONEER DC-J210 will begin.