User manual PIONEER DCR-111

[. . . ] To ensure your personal safety and to maximize the full operating potential of your Drive, read and follow these safety precautions: ENVIRONMENT - Please do not use the unit at places with much dust, high temperature, or high humidity. Please use the unit at a place where it is not subjected to vibrations or shocks. POWER - Before installing the unit on the system, be sure to turn off power on the system and remove the power cord from the AC outlet. READ INSTRUCTIONS - Read all safety and operating instructions before the Drive is operated. [. . . ] SERVICING - Do not attempt to repair this product yourself. Opening or removing covers may expose you to dangerous voltage or other hazards. Remove dust or lint from the disc with a soft cloth by wiping from the inside to the outside edge rather than in a circular motion. ã· Do not use record-cleaning or anti-static agents as the solutions may cause damage to a disc. Always be sure to store your discs in proper DVD/CD storage cases when not in use, and always be sure to check for dirt or dust on discs (especially on the recording side) before use. This product can read out DVD-RW disc data. Note the following: (1) A little longer time is needed to sense a DVD-RW disc when the operation starts, compared with standard DVD-ROM discs. (2) Since playback signal level of DVD-RW is lower than the replicated DVD discs, reading speed of those discs is lower than that of the replicated discs to ensure data reading. (3) Blank discs, discs that you failed to write data or discs that session close processing has not been made - these discs cannot be used. (4) The operations may not start or the data may not be read out under the following conditions: The quality of the recorded signal has deteriorated due to the dirt or scratches on the disc, or frequently rewrote discs. If you fail to start the operation, take out the disc and reinsert it to try again to start. 15") disc cannot be played even an adapter is attached to the disc when the drive is upright condition. Place a CD or DVD disc with the label facing up onto the tray. This is used to adjust the volume for the headphone jack. This button is used to open and close the tray. When the eject button has lost its function, insert a stiff rod into this hole and push to eject the disc tray. WARNING: Before executing this operation, be sure the power supply of the computer is off and check the disc rotation is stopped. 60 seconds to stop disc rotation after turning off the power supply. The region code can be changed ONLY 5 times, including the 1st setting. Please be aware the 5th change will be PERMANENT, therefore, please pay attention when changing region codes. [. . . ] , the vibrations from disc rotation may generate ripping noise, to prevent it the screws should be tightened securely. Connect the power cable from the personal computer. When a sound card is being used, connect the audio output with an audio cable to the sound card. Be sure to supply electrical power for this product from the personal computer which is connected to it. [. . . ]