User manual PIONEER DCS-585

[. . . ] RISK OF ELECTRIC SHOCK DO NOT OPEN The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. When installing this unit, make sure to leave space around the unit for ventilation to improve heat radiation (at least 10 cm at top, 10 cm at rear, and 10 cm at each side). Slots and openings in the cabinet are provided for ventilation to ensure reliable operation of the product, and to protect it from overheating. To prevent fire hazard, the openings should never be blocked or covered with items (such as newspapers, table-cloths, curtains) or by operating the D3-4-2-1-7b_A_En equipment on thick carpet or a bed. [. . . ] With large amounts of data, it may take longer for the system to read the contents of a USB device. Some USB devices may not be properly recognized. Even when they are in a supported format, some files may not play or display depending on the content. The screen shown below is displayed during recording. CD -> USB Rec can only be selected when the music CD is stopped. 6 Select `Start' using the ///, then press ENTER. 1 Recording cannot be started if there is not enough free space on the USB device. In this case, "Available USB space is low" is displayed. 2 · When recording is finished, a folder named "PIONEER" is created automatically on the USB device. The recorded tracks are stored in this folder. When recording on a USB device is under way, all DVD-related key operations are disabled except for the operation of STANDBY/ON and OPEN/CLOSE buttons and switchover of the functions. When the sleep timer is ON, it is cancelled once recording on a USB device is started. From the Sound Setup menu you can access all the surround sound settings of the system, including channel levels, speaker distances, dynamic range, CD Type and Sound Field adjustment. The Auto MCACC feature (page 17) should give you the best surround sound setup. However you may find that by further adjustment of the surround sound settings you can improve the surround sound in your listening room. 1 Press SHIFT+SETUP and use / to select SOUNDSET then press ENTER to choose the setting you want to adjust. The available settings are shown in the front panel display. Note that using the Auto MCACC (page 17) again overwrites the speaker settings. Speaker distance setting (DISTANCE) Not applicable to the DCS-FS30 model Specifies the distance from your listening position to your speakers. When DISTANCE appears, press ENTER, then use / to adjust the distance, and / to switch between the following speakers: · SW ­ Subwoofer Each speaker can be adjusted between 0. Not applicable to the DCS-FS30 model Set the relative channel levels from your main listening position. 2 Use / to switch between channels in the following order: · If low level sound or dialogue seem difficult to hear properly, this can help by bringing up the low level sounds, while controlling high level peaks. [. . . ] If this problem is not fixed by removing and inserting the power cable, this unit may be damaged. In such an event, please contact a Pioneerauthorized service center or your nearest dealer. Power consumption by Bluetooth ADAPTER is too high to supply the power. Indicator is lit for two seconds if the listening mode is changed while HDMI audio mode is set for TV. [. . . ]