User manual PIONEER DD-S5001

[. . . ] Be sure that the power supply voltage of the area where this unit will be used meets the required voltage (e. , 230 V or 120 V) written on the bottom panel. Do not pull out the plug by tugging the cord and never touch the power cord when your hands are wet as this could cause a short circuit or electric shock. Do not place the unit, a piece of furniture, etc. [. . . ] To attach, first place the protruding tabs on the front side of the adaptor into the depressions on the iPod connector port and press into position. When attaching the adaptor, be careful not to strike the connectors. Before making or changing the connections, switch off the power and disconnect the power cord from the power outlet. To watch iPod images on a television, perform connections using either a composite video cable or component video cable. When using a component video cable for connections, it is necessary to adjust the unit's video output. When an iPod is connected to this unit, the iPod's TV output setting is automatically set to ON. While connected, the iPod can be used to switch the TV output setting. Adjust the video output on this unit in accordance with the method used to connect the television. When the iPod is disconnected from this unit, the iPod's TV output setting returns to its original state. During the video output setting process, if no button operation is performed for 3 minutes, the setting will be canceled and power will return to the standby mode. The setting will be completed, and the display for the newly set value will flash for three seconds, after which the power will once again switch to standby mode. When there is no response from the iPod, update the iPod software to the latest version. If this doesn't seem to work, try resetting your iPod. 1 When the Bluetooth ADAPTER is not plugged in the ADAPTER PORT, cannot be selected even if INPUT is pressed. 2 · Pairing is required when you first use Bluetooth wireless technology device and Bluetooth ADAPTER. To enable Bluetooth communication, pairing should be done with both of your system and Bluetooth wireless technology device. Listening to Music Contents of Bluetooth wireless technology device with Your System The following operations are now possible for Bluetooth wireless technology devices, using the remote control. Bluetooth wireless technology device should be compatible with AVRCP profile. Depending on Bluetooth wireless technology device you use, operation may differ from what is shown in this table. Before making or changing the connections, switch off the power and disconnect the power cord from the AC outlet. This method can be used to play music on this unit from iPods that do not support use of an iPod Dock. Connect the FM antenna plug onto the center pin of the FM antenna socket. [. . . ] Sometimes the trouble may lie in another component. Investigate the other components and electrical appliances being used. If the trouble cannot be rectified even after exercising the checks listed below, ask your nearest Pioneer authorized service center or your dealer to carry out repair work. If the unit does not operate normally due to external effects such as static electricity disconnect the power plug from the outlet and insert again to return to normal operating conditions. [. . . ]