User manual PIONEER DEH-1250MP

[. . . ] Thank you for purchasing this PIONEER product. To ensure proper use, please read through this manual before using this product. It is especially important that you read and observe WARNINGs and CAUTIONs in this manual. Please keep the manual in a safe and accessible place for future reference. [. . . ] Depending on the version of iTunes used to write MP3 files onto a disc, comment information may be incorrectly displayed. When playing back VBR (variable bit rate)-recorded WMA files, the average bit rate value is displayed. Using the COMP (compression) and BMX functions let you adjust the sound playback quality of this unit. FF/REV (fast forward/reverse) You can switch the search method between fast forward/reverse and searching every 10 tracks. Selecting ROUGH enables you to search every 10 tracks. FF/REV ­ Fast forward and reverse ROUGH ­ Searching every 10 tracks To select FF/REV, press c. If the rest of track number is less than 10, press and hold c or d recalls the first (last) one. SLA (source level adjustment) SLA (Source level adjustment) lets you adjust the volume level of each source to prevent radical changes in volume when switching between sources. Settings are based on the FM volume level, which remains unchanged. Before adjusting source levels, compare the FM volume level with the level of the source you wish to adjust. The AM volume level can also be adjusted with source level adjustments. After selecting, perform the following procedures to set the audio function. Adjustment range (front/rear): FAD F15 to FAD R15 FAD 0 is the proper setting when only two speakers are used. You can also turn loudness on or off by pressing and holding EQ/LOUD. CUSTOM allows you to create a customized setting. When FLAT is selected no adjustments are made to the sound. 1 Press SRC/OFF and hold until the unit turns off. After selecting, perform the following procedures to set the initial setting. The FM tuning step employed by seek tuning can be switched between 100 kHz, the preset step, and 50 kHz. Tune in the stations with manual tuning or use seek tuning again. 1 Press c or d to select the FM tuning step. 50 (50 kHz)--100 (100 kHz) AM (AM tuning step) The AM tuning step can be switched between 9 kHz, the preset step, and 10 kHz. [. . . ] 1 Determine the appropriate position where the holes on the bracket and the side of the unit match. Releasing the front panel allows easier access to the trim ring. 2 Insert the supplied extraction keys into both sides of the unit until they click into place. Cause Action (See) FRMTREAD You did not per- Perform operation form any opera- again. [. . . ]