User manual PIONEER DEH-150MPG

[. . . ] ователя Italiano Español Deutsch Nederlands Русский Section 01 02 Before you start Operating this unit Thank you for purchasing this PIONEER product To ensure proper use, please read through this manual before using this product. It is especially important that you read and observe WARNINGs and CAUTIONs in this manual. Please keep the manual in a safe and accessible place for future reference. About this unit The tuner frequencies on this unit are allocated for use in Western Europe, Asia, the Middle East, Africa and Oceania. [. . . ] It may be preferable to set the tuning step to 50 kHz when AF is on. The tuning step remains at 50 kHz during manual tuning. 50 (50 kHz)—100 (100 kHz) SP-P/O MODE (rear output and preout setting) English Switching the dimmer setting You can adjust the brightness of illumination. The rear speaker leads output and the RCA output of this unit can be used to connect a full-range speaker or subwoofer. You can select any one of the options in the following list: !W – Select when there is a fullrange speaker connected to the rear speaker leads output and there is a subwoofer connected to the RCA output. W – Select when there is a subwoofer connected directly to the rear speaker leads output without any auxiliary amp and there is a subwoofer connected to the RCA output. REAR/REAR – Select when there is a fullrange speaker connected to the rear speaker leads output and the RCA output. If there is a full-range speaker connected to the rear speaker leads output and the RCA output is not used, you may select either REAR/SUB. You can also change the dimmer setting by pressing and holding /DIMMER. System menu 1 Press and hold SRC/OFF until the unit turns off. 2 Press and hold SRC/OFF until the main menu appears in the display. Once selected, the following system menu functions can be adjusted. Initial menu 1 Press and hold SRC/OFF until the unit turns off. 2 Press and hold SRC/OFF until the main menu appears in the display. When installing this unit in a vehicle without an ACC (accessory) position on the ignition switch, failure to connect the red cable to the terminal that detects operation of the ignition key may result in battery drain. F Using an AUX source 1 Insert the stereo mini plug into the AUX input jack. 2 Press SRC/OFF to select AUX as the source. Note AUX cannot be selected unless the auxiliary setting is turned on. For more details, refer to AUX (auxiliary input) on the previous page. O N ACC position No ACC position Switching the display Selecting the desired text information 1 Press DISP to cycle between the following: !Use of this unit in conditions other than the following could result in fire or malfunction. [. . . ] Serious scratches can lead to playback problems on this unit. In some cases, a DualDisc may become stuck in the disc loading slot and will not eject. To prevent this, we recommend you refrain from using DualDisc with this unit. Please refer to the information from the disc manufacturer for more detailed information about DualDiscs. [. . . ]