User manual PIONEER DEH-1600UBG

[. . . ] ователя Italiano Español Deutsch Nederlands Русский <QRD3204-A>1 Black plate (2, 1) Section 01 Before you start Before you start Thank you for purchasing this PIONEER product To ensure proper use, please read through this manual before using this product. It is especially important that you read and observe WARNINGs and CAUTIONs in this manual. Please keep the manual in a safe and accessible place for future reference. About this unit The tuner frequencies on this unit are allocated for use in Western Europe, Asia, the Middle East, Africa and Oceania. [. . . ] You can also change the dimmer setting by pressing and holding /DIMMER. MUTE MODE (mute mode) En 7 <QRD3204-A>7 Black plate (8, 1) Section 02 03 Using this unit Installation Using an AUX source 1 Insert the stereo mini plug into the AUX input jack. 2 Press SRC/OFF to select AUX as the source. Note AUX cannot be selected unless the auxiliary setting is turned on. When installing this unit in a vehicle without an ACC (accessory) position on the ignition switch, failure to connect the red cable to the terminal that detects operation of the ignition key may result in battery drain. O N Switching the display Selecting the desired text information 1 Press DISP to cycle between the following: !Use of this unit in conditions other than the following could result in fire or malfunction. If an unwanted display appears Turn off the unwanted display using the procedures listed below. To prevent a short-circuit, overheating or malfunction, be sure to follow the directions below. € Disconnect the negative terminal of the battery before installation. € Secure the wiring with cable clamps or adhesive tape. Wrap adhesive tape around wiring that comes into contact with metal parts to protect the wiring. € Place all cables away from moving parts, such as the shift lever and seat rails. € Place all cables away from hot places, such as near the heater outlet. € Do not connect the yellow cable to the battery by passing it through the hole to the engine compartment. € Cover any disconnected cable connectors with insulating tape. € Never cut the insulation of the power cable of this unit in order to share the power with other devices. The current capacity of the cable is limited. When this unit is on, control signals are sent through the blue/white cable. Connect this cable to the system remote control of an external power amp or the vehicle’s auto-antenna relay control terminal (max. If the vehicle is equipped with a glass antenna, connect it to the antenna booster power supply terminal. Never connect the blue/white cable to the power terminal of an external power amp. [. . . ] Playable files: up to 15 000 Playback of copyright-protected files: Not compatible Partitioned USB storage device: Only the first partition can be played. There may be a slight delay when starting playback of audio files on a USB storage device with numerous folder hierarchies. USB storage device Playback sequence is the same as recorded sequence in the USB storage device. To specify the playback sequence, the following method is recommended. [. . . ]