User manual PIONEER DEH-22UB

[. . . ] Insert the supplied extraction keys into the unit, as shown in the figure, until they click into place. Keeping the keys pressed against the sides of the unit, pull the unit out. This product conforms to new cord colors. About the fixing screws for the front panel If you do not operate the Removing and Attaching the Front Panel Function, use the supplied fixing screws and fix the front panel to this unit. [. . . ] After inserting the holder into the dashboard, then select the appropriate tabs according to the thickness of the dashboard material and bend them. (Install as firmly as possible using the top and bottom tabs. In this case, be sure to connect 2* to 5* and 4* to 3*. Cap (1*) When not using this terminal, do not remove the cap. This unit is for vehicles with a 12-volt battery and negative grounding. To avoid shorts in the electrical system, be sure to disconnect the battery cable before beginning installation. â· Refer to the owner's manual for details on connecting the power amp and other units, then make connections correctly. To protect the wiring, wrap adhesive tape around them where they lie against metal parts. â· Route and secure all wiring so it cannot touch any moving parts, such as the gear shift, handbrake and seat rails. Do not route wiring in places that get hot, such as near the heater outlet. If this is not done, the vehicle battery may be drained when you are away from the vehicle for several hours. In this case, be sure to connect 2* to 5* and 4* to 3*. Cap (1*) When not using this terminal, do not remove the cap. Yellow (2*) To terminal always supplied with power regardless of ignition switch position. ISO connector Note: In some vehicles, the ISO connector may be divided into two. In this case, be sure to connect to both connectors. Speaker leads White : Front left + White/black : Front left Gray : Front right + Gray/black : Front right Green : Rear left + Green/black : Rear left Violet : Rear right + Violet/black : Rear right 16. In another type of vehicle, never connect 6* and 7*. Perform these connections when using the optional amplifier. Yellow (2*) To terminal always supplied with power regardless of ignition switch position. [. . . ] Perform these connections when using the optional amplifier. Yellow (2*) To terminal always supplied with power regardless of ignition switch position. In another type of vehicle, never connect 6* and 7*. Perform these connections when using the optional amplifier. [. . . ]