User manual PIONEER DEH-2770MP

[. . . ] (Install as firmly as possible using the top and bottom tabs. Fastening the unit to the factory radio mounting bracket. Select a position where the screw holes of the bracket and the screw holes of the head unit become aligned (are fitted), and tighten the screws at 2 places on each side. Use either truss screws (5 × 8 mm) or flush surface screws (5 × 9 mm), depending on the shape of the screw holes in the bracket. [. . . ] Insert the release pin into the hole in the bottom of the frame and pull out to remove the frame. Insert the supplied extraction keys into the unit, as shown in the figure, until they click into place. Keeping the keys pressed against the sides of the unit, pull the unit out. Support Après avoir introduit le support dans le tableau de bord, sélectíonnez les languettes appropriées en fonction de l'épaisseur du matériau du tableau de bord et courbez-les. This unit is for vehicles with a 12-volt battery and negative grounding. before installing it in a recreational vehicle , truck , or bus , check the battery voltage. To avoid shorts in the electrical system, be sure to disconnect the battery cable before beginning installation. Refer to the owner's manual for details on connecting the power amp and other units, then make connections correctly. secure the wiring with cable clamps or adhesive tape. To protect the wiring, wrap adhesive tape around them where they lie against metal parts. Route and secure all wiring so it cannot touch any moving parts, such as the gear shift, handbrake and seat rails. In this case, be sure to connect 2* to 5* and 4* to 3*. Cap (1*) When not using this terminal, do not remove the cap. Yellow (2*) To terminal always supplied with power regardless of ignition switch position. ISO connector Note: In some vehicles, the ISO connector may be divided into two. In this case, be sure to connect to both connectors. Yellow/black If you use a cellular telephone, connect it via the Audio Mute lead on the cellular telephone. If not, keep the Audio Mute lead free of any connections. Speaker leads White : Front left + White/black : Front left Gray : Front right + Gray/black : Front right Green : Rear left + Green/black : Rear left Violet : Rear right + Violet/black : Rear right 21. In another type of vehicle, never connect 6* and 7*. Perform these connections when using the optional amplifier. In this case, be sure to connect 2* to 5* and 4* to 3*. [. . . ] Cap (1*) When not using this terminal, do not remove the cap. Yellow (2*) To terminal always supplied with power regardless of ignition switch position. In another type of vehicle, never connect 6* and 7*. Speaker leads White : Front left + White/black : Front left Gray : Front right + Gray/black : Front right Green : Rear left + Green/black : Rear left Violet : Rear right + Violet/black : Rear right 31. [. . . ]