User manual PIONEER DEH-80PRS

[. . . ] € Never cut the insulation of the power cable of this unit in order to share the power with other devices. The current capacity of the cable is limited. When this unit is on, control signals are sent through the blue/white cable. Connect this cable to the system remote control of an external power amp or the vehicle’s auto-antenna relay control terminal (max. [. . . ] The following signals are output from the speaker leads when this connection is in use. White: Front left + White/black: Front left * Gray: Front right + Gray/black: Front right * Green: Rear left + Green/black: Rear left * Violet: Rear right + Violet/black: Rear right * 1 5   3 2   4 5 3 6 7 3 2   3 2   4 5 3 6 7 3 1 9 2     8 9 2   3 2   4 5 1 9 2     8 9 3 2   4 5 1 System remote control Connect to Blue/white cable. 2 Power amp (sold separately) 3 Connect with RCA cable (sold separately) 4 To low range output 5 Low range speaker 1 System remote control Connect to Blue/white cable. 2 Power amp (sold separately) 3 Connect with RCA cable (sold separately) 4 To high range output 5 High range speaker 6 To middle range output 7 Middle range speaker 8 To low range output 9 Low range speaker Switching the DSP setting mode This unit features two operation modes: the 3way network mode (NW) and the standard mode (STD). You can switch between modes as desired. Initially, the DSP setting is set to the standard mode (STD). After switching, reset the microprocessor. For more details on change settings, refer to the operation manual or Switching the DSP setting mode on this page. En 3 Section 01 02 Connections Installation WARNING Do not use the unit in standard mode when a speaker system for 3-way network mode is connected to this unit. 1 Use a thin, flathead screwdriver to change the DSP switch on the bottom of this unit. 2 To audio output 3 Connect with RCA cable (sold separately) 4 To audio input If connecting the unit to a car stereo with no RCA output 2 3 4 5 6 7 8 1 Important !Do not use unauthorized parts as this may cause malfunctions. Consult your dealer if installation requires drilling of holes or other modifications to the vehicle. Do not install this unit where: — it may interfere with operation of the vehicle. € it may cause injury to a passenger as a result of a sudden stop. Use commercially available parts when installing. DIN Front-mount 1 Insert the mounting sleeve into the dashboard. For installation in shallow spaces, use the supplied mounting sleeve. If there is enough space, use the mounting sleeve that came with the vehicle. 2 Secure the mounting sleeve by using a screwdriver to bend the metal tabs (90°) into place. 1 1 2 3 4 5 6 7 2 Press RESET with a pen tip or other pointed instrument. For details, refer to the operation manual. [. . . ] ) 3 4 1 Microphone 2 Microphone base 3 Microphone clip 4 Fit the microphone lead into the groove. # Microphone can be installed without using microphone clip. In this case, detach the microphone base from the microphone clip. To detach the microphone base from the microphone clip, slide the microphone base. [. . . ]