User manual PIONEER DEH-9300SD

[. . . ] Operation Manual CD RDS RECEIVER DEH-9300SD English Contents Thank you for purchasing this PIONEER product. To ensure proper use, please read through this manual before using this product. It is especially important that you read and observe WARNINGs and CAUTIONs in this manual. Please keep the manual in a safe and accessible place for future reference. Before You Start About this unit 3 In case of trouble 3 Demo mode 3 Reverse mode 4 Sound muting 4 About this manual 4 Operating this unit Head unit 5 Optional remote control 5 Basic Operations 6 Menu operations identical for function settings/audio adjustments/initial settings/ lists 6 Tuner 6 CD/CD-R/CD-RW and external storage devices (USB, SD) 9 iPod 11 Audio Adjustments 13 Initial Settings 15 Other Functions 16 Additional Information Troubleshooting 18 Error messages 18 Handling guidelines 20 Compressed audio compatibility (disc, USB, SD) 21 iPod compatibility 23 Sequence of audio files 23 Copyright and trademark 23 Specifications 25 2 En Section Before You Start 01 Before You Start If you want to dispose this product, do not mix it with general household waste. There is a separate collection system for used electronic products in accordance with legislation that requires proper treatment, recovery and recycling. CAUTION This product is a class 1 laser product classified under the Safety of laser products, IEC 60825-1:2007, and contains a class 1M laser module. [. . . ] You can match the clock to a time signal by pressing M. C. If 00 to 29, the minutes are rounded down. If 30 to 59, the minutes are rounded up. (e. g. , 10:36 becomes 11:00. ) EngineTime alert (elapsed time display setting) This setting allows you to switch your source to USB/ IPOD automatically. to turn the plug and play function on or off. ON ­ When USB storage device/iPod is connected, the source is automatically switched to USB/IPOD. If you disconnect your USB storage device/iPod, this unit's source is turned off. OFF ­ When USB storage device/iPod is connected, the source does not switch to USB/ IPOD automatically. Please manually change the source to USB/IPOD. Warning tone (warning tone setting) If the front panel is not detached from the head unit within four seconds of turning off the ignition, a warning tone sounds. AUX (auxiliary input) Activate this setting when using an auxiliary device connected to this unit. Dimmer (dimmer setting) To prevent the display from being too bright at night, the display is automatically dimmed when the car's headlights are turned on. to turn dimmer on or off. 02 Operating this unit 1 1 Function display !1 Press and hold SRC/OFF until the unit turns off. and hold until the initial setting menu appears in the display. After selecting, perform the following procedures to set the initial setting. En 15 Section 02 Operating this unit Brightness (display brightness setting) 1 Push M. C. left or right to adjust the brightness level. 0 to 15 is displayed as the level is increased or decreased. When dimmer is functioning, the brightness level can be adjusted 0 to 10. S/W control (rear output and subwoofer setting) This unit's rear output (rear speaker leads output and RCA rear output) can be used for full-range speaker (Rear SP :F. Range) or subwoofer (Rear SP :S/W) connection. If you switch the rear output setting to Rear SP :S/W, you can connect a rear speaker lead directly to a subwoofer without using an auxiliary amp. When no subwoofer is connected to the rear output, select Rear SP :F. Range (full-range speaker). [. . . ] 72 dB (IEC-A network) MW tuner Frequency range . . . . . . . . . . . . . . . . . . . . . . 531 kHz to 1 602 kHz (9 kHz) Usable sensitivity . . . . . . . . . . . . . . . . . . . . . 25 µV (S/N: 20 dB) Signal-to-noise ratio . . . . . . . . . . . . . . . 62 dB (IEC-A network) CD player System . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]