User manual PIONEER DEH-P47DH

[. . . ] To protect the wiring, wrap adhesive tape around them where they lie against metal parts. Route and secure all wiring so it cannot touch any moving parts, such as the gear shift, handbrake and seat rails. Do not route wiring in places that get hot, such as near the heater outlet. [. . . ] If this is not done, the vehicle battery may be drained when you are away from the vehicle for several hours. 7 When not connecting a rear speaker lead to a Subwoofer Power amp (sold separately) Subwoofer output or Non Fading output To system control terminal of the power amp or Auto-antenna relay control terminal (max. This product Caution: Connect the supplied connector without fail. If connectors other than the one supplied with this product are used, there is the possibility that sounds may mute and memorized information could be erased. Please ground this lead separately from the ground of high-current products such as power amps. If you ground the products together and the ground becomes detached, there is a risk of damage to the products or fire. Cords for this product and those for other products may be different colors even if they have the same function. When connecting this product to another product, refer to the supplied Installation manuals of both products and connect cords that have the same function. To terminal always supplied with power regardless of ignition switch position. If you use a cellular telephone, connect it via the Audio Mute lead on the cellular telephone. If not, keep the Audio Mute lead free of any connections. Yellow Fuse holder Yellow/black With a 2 speaker system, connect to the 2 speakers in the front or the rear. Use this for connections when you have the separately available amplifier. 7 When using a Subwoofer without using a different amp (sold separately) Before finally installing the unit, connect the wiring temporarily, making sure it is all connected up properly, and the unit and the system work properly. [. . . ] Fit the bracket provided on the vehicle to the unit in the same way that it was fitted to the original car stereo. Fit the bracket provided on the vehicle to the unit in the same way that it was fitted to the original car stereo. Vehicle supplied screw (not included) Tube spacer Bracket Screw (3 × 5 mm) Vehicle supplied screw (not included) Bracket Screw (3 × 5 mm) Dash panel Vehicle supplied screw (not included) Bracket Screw (3 × 5 mm) Vehicle supplied screw (not included) Bracket (not included) In some cases, this may not be provided on the vehicule. [. . . ]